DIY trickle filter

[spiral_72]

I'm researching/designing my own wet/dry trickle filter. There seems to
be an abundance of info on the net but one thing still baffles me. How
is everyone getting a $15 powerhead to lift water from the filter back
into the top of the tank? I have tried several methods with the 300gph
powerhead I have, but it stalls at 2ft of lift.

My tank lid is about 4ft from the floor (55gal on a stand). I expect
whatever pump I use will need to lift 3.5ft at 125gph or so. With those
requirements I am looking at a pond or fountain pump. Yes?

[Daniel Morrow]

"spiral_72" > wrote in message
ups.com...
> I'm researching/designing my own wet/dry trickle filter. There seems to
> be an abundance of info on the net but one thing still baffles me. How
> is everyone getting a $15 powerhead to lift water from the filter back
> into the top of the tank?

If the whole wet/dry trickle filter system is sealed like a canister filter
it should work fine for you.

I have tried several methods with the 300gph
> powerhead I have, but it stalls at 2ft of lift.
>
> My tank lid is about 4ft from the floor (55gal on a stand). I expect
> whatever pump I use will need to lift 3.5ft at 125gph or so. With those
> requirements I am looking at a pond or fountain pump. Yes?

Check out www.thatpetplace.com for danner mag pumps. Even something as cheap
as a mag#2 might do everything you need. Keep in mind that powerheads (for
the same amount of electrical energy) pump more current but at a lower
pressure (less head height) while pumps pump less current at a higher
pressure. I think you will get better/more bang for your buck from danner
mag pumps, good luck later!