Buckaroo
August 22nd 03, 03:35 AM
Yes, it was a bad design decision...they needed a knob there to turn, not a
screw slot! Further, always getting the open position aligned to get the
cover off can be deceptive, and a pain!
"Eric Schreiber" > wrote in message
...
> (Kate) wrote:
>
> >I have an Eclipse and need to change the lightbulb or stabilise it so
> >it stays on. there are two little plastic screws but they don't seem
> >to come out. what am I missing?
>
> Assuming yours is similar to the Eclipse 2 hood, you're right - the
> screws don't come out. Just turn them 90 degrees counter clockwise,
> and the clear light cover will come right off.
>
> --
> www.ericschreiber.com
screw slot! Further, always getting the open position aligned to get the
cover off can be deceptive, and a pain!
"Eric Schreiber" > wrote in message
...
> (Kate) wrote:
>
> >I have an Eclipse and need to change the lightbulb or stabilise it so
> >it stays on. there are two little plastic screws but they don't seem
> >to come out. what am I missing?
>
> Assuming yours is similar to the Eclipse 2 hood, you're right - the
> screws don't come out. Just turn them 90 degrees counter clockwise,
> and the clear light cover will come right off.
>
> --
> www.ericschreiber.com