View Full Version : Nymphaea suggestion for a small pond
Plantaganet
July 14th 06, 10:12 PM
Hi,
I would like to add a miniature leaved, white or soft cream flowered
Nymphaea to my very small, shallow garden pond. The depth of water at
the deepest section is only 18 inches. I understand that miniature
water lilies have a leaf spread of about 12 to 18 sq. in., so one plant
should be quite adequate. As the spread will need to be restricted, it
appears that I should buy a container grown plant. Any variety
suggestions would be most welcome. At the moment the only plant I have
in my pond is a Juncus effusus 'Spiralis'.
Thanks, in advance.
Plntaganet
--
Plantaganet
sean mckinney
July 15th 06, 12:27 PM
there is or are pygmy whites and from memory it is tetragonna alba,
however there is frequent confusion over the name and my first pygmy
white isnt a pygmy. I am trying a second from Paul Bromfields but dont
remember the name at the moment.
You might also like to look at "helvola" which is a yellow. If you
would accept other colours then look at rubra (a pinkish red) and maybe
Laydekeri_fulgens also a pinky red what I was sold as that is a pygmy
but I am not sure if it is correct. Aurora but that hasnt bloomed for
me yet.
If you are in the states you will probably have a greater choice range
but the above are available in the UK. Aside from the local garden
centre if you are UK have a look at
http://www.pondplants.co.uk/
http://www.bromfieldaquatics.co.uk/
and perhaps http://tinyurl.com/c2opr
--
sean mckinney
Plantaganet
July 15th 06, 08:48 PM
sean mckinney Wrote:
>
> snip
> You might also like to look at "helvola" which is a yellow. If you
> would accept other colours then look at rubra (a pinkish red) and maybe
> Laydekeri_fulgens also a pinky red what I was sold as that is a pygmy
> but I am not sure if it is correct. Aurora but that hasnt bloomed for
> me yet.
> ----
> Thanks Sean, After reading your reply, I decided to go for the yellow
> 'Helvola' and have ordered N. pygmaea 'Helvola' from Wildwoods Water
> Gardens. www.wildwoods.co.uk
--
Plantaganet
sean mckinney
July 16th 06, 01:42 PM
When planting, I did try the bought soils but am reverting to riddled
garden soils, wet it to the consistancey of mud pies and add enough to
make a layer say 1/2 thick. Flatten that out and then sprinkle some
Osmocote fertiliser graunules on top of that. Garden centres sell it as
prepack loose granules like barley grains or in pellet form like a
bottle cork. B&Q also sell both types. Its a slow release fertiliser
even apparently in water. Then add about another inch of mud and then
set the cutting on top of that with the crown uppermost. Pack more mud
around the cutting but leave the crown just above the level of the
mud.
The cutting should go into roughly the centre of the pot or if the
crown/s are a one end of the rhyzome place the rhyzome towards the
outside of the pot with the crown/s towards the centre of the pot, the
rhyzomes tend to grow from around the crown/s. I would then put the
lily in a bucket of preferably a trug until it established its self,
probably a month but in this weather try shade the bucket without
shading the pads, dont be surprised if all or most of the pads die off
fairly quickly. Watch the cutting but resist the temptation to poke at
it. If in a trug remove any snails you see because with no dead plant
matter around they will have only the lily to eat. Also watch for the
pads being gradually eaten by something you cannot see, I think there
is an 'invisible' midge larvae that eats the pads. If the pads do seem
to be being eaten I have been told that a copper sulphate solution will
kill all animal life in the water but you would need to do your own
research into that. I couldnt get to a garden centre to get copper
sulphate so put the 'infected' lily in my plant pond and the tadploes
seemed to eat the problem.
Hope that helps
--
sean mckinney
vBulletin® v3.6.4, Copyright ©2000-2025, Jelsoft Enterprises Ltd.