question about trickle filters...

[Jon Pike]

I've recently 'upgraded' my tank to include a trickle filter design.
Basically, two pvc tubes take water in from just below the water level and
carry it down to the sump below. It's then pumped back up to the other side
of the tank. My question is, how do I make the input less noisy? I put fine
netting over top, and that reduced the sound somewhat, but now there's a
higher pitched occasional sucking sound. Any suggestions?
TIA

--
http://www.neopets.com/refer.phtml?username=moosespet

[Runner]

"Jon Pike" > wrote in message
. 159...
> I've recently 'upgraded' my tank to include a trickle filter design.
> Basically, two pvc tubes take water in from just below the water level and
> carry it down to the sump below. It's then pumped back up to the other
side
> of the tank. My question is, how do I make the input less noisy? I put
fine
> netting over top, and that reduced the sound somewhat, but now there's a
> higher pitched occasional sucking sound. Any suggestions?
> TIA

Try making a custom standpipe overflow as shown at this link:

http://www.rl180reef.com/pages/standpipe/standpipe_frame.htm

Here is another good one to try if it fits your application better:

http://home.att.net/~rstockman/overflow.htm

Good luck.
-Scott

[Mat]

I take it a trickle filter is one that goes down a slope to the bottom and
pumped to the top again?

You may need to adjust the bottom pipe it sounds like its to far out the
water. so just raise the water level of lower the pipe.

Mat
"Jon Pike" > wrote in message
. 159...
> I've recently 'upgraded' my tank to include a trickle filter design.
> Basically, two pvc tubes take water in from just below the water level and
> carry it down to the sump below. It's then pumped back up to the other
side
> of the tank. My question is, how do I make the input less noisy? I put
fine
> netting over top, and that reduced the sound somewhat, but now there's a
> higher pitched occasional sucking sound. Any suggestions?
> TIA
>
> --
> http://www.neopets.com/refer.phtml?username=moosespet

[Tin-Tin]

Mat wrote:

> I take it a trickle filter is one that goes down a slope to the
> bottom and pumped to the top again?
>
> You may need to adjust the bottom pipe it sounds like its to far out
> the water. so just raise the water level of lower the pipe.
>
> Mat "Jon Pike" > wrote in message
> . 159...
>
>> I've recently 'upgraded' my tank to include a trickle filter
>> design. Basically, two pvc tubes take water in from just below the
>> water level and carry it down to the sump below. It's then pumped
>> back up to the other
>
> side
>
>> of the tank. My question is, how do I make the input less noisy? I
>> put
>
> fine
>
>> netting over top, and that reduced the sound somewhat, but now
>> there's a higher pitched occasional sucking sound. Any suggestions?
>> TIA - Make sure no air gets pumped in. Air in the pump is often
>> responsible for such noises.
Tin-Tin

>> http://www.neopets.com/refer.phtml?username=moosespet
>
>
>

[Mat]

I've that does not work you may need to take a little aquarium water out, to
just above the line of the pvc tube to try and stop the noise. I tried it
with a system they had at a shop. I put my thumb over the tube to stop water
going down and let go after 5 seconds and it made a noise as the water level
was returning to normal and then it stopped.

Mat
"Jon Pike" > wrote in message
. 159...
> I've recently 'upgraded' my tank to include a trickle filter design.
> Basically, two pvc tubes take water in from just below the water level and
> carry it down to the sump below. It's then pumped back up to the other
side
> of the tank. My question is, how do I make the input less noisy? I put
fine
> netting over top, and that reduced the sound somewhat, but now there's a
> higher pitched occasional sucking sound. Any suggestions?
> TIA
>
> --
> http://www.neopets.com/refer.phtml?username=moosespet