|
|
|
|
7 |
1,221 |
|
|
CRX no start and dying while driving :( by
[email protected]
So my '89 CRX HF with LS motor has been giving me a total headache.
Two years ago it died and would not start for a few months. I didn't
do anything with it since I had another car and no time to work on it.
But then one day it started up again. No problems for a year. The
weather turned really...
( 1 2)
|
|
12 |
1,221 |
|
|
timing belt question... by
qslim
sorry about the blank post, hit enter instead of tab...
anyway, gotta pop in another timing belt & water pump on my 92 accord,
what do you honda guys use to immobilise the cam shaft whilst replacing
the cam seal??
|
|
1 |
1,221 |
|
|
1991 Civic warm up time by
[email protected]
This is the 3rd winter I have owned this 1991
Civic. The first winter I owned it I replaced
the OEM thermostat because it took way too long
to warm up, and on really cold (-12F) days, the
engine temp gauge dipped when I would run the
heater wide open. It hasn't been that cold since
so I don't know...
|
|
9 |
1,221 |
|
|
No help or wrong help for Detroit? by
Ed Pirrero
Brent P wrote:
>
>
> Considering the union contracts, they are basically running a
> welfare/entitlement government operation.
Actually, no. They are trying to sell a product and have a skilled
workforce to accomplish that goal.
The unions did not design and build the turds the marketing...
( 1 2 3 ... Last Page)
|
|
31 |
1,220 |
|
|
Question on Interior Metal Trim Kit by
Mitchell Freeman
Hello,
I am looking at purchasing a new Accord, and one of the options is this
interior metal trim kit. It looks awfully nice in the brochure, but I have
no idea how well it holds up under actual occupancy. Has anyone had one of
these kits that could share their experience with it? Imagine having...
|
|
0 |
1,219 |
|
|
|
|
1 |
1,218 |
|
|
remanufactured compressor AC by
Philippe MÉRY
Hello from France
on Prelude 3° gen the AC compressor is dead :-(
We are in France and remanufacturing AC compressor is not usual not as in Us
or Canada...
Is it safe and reliable to look toward a remanufactured one?
Some people in France says it is not a longlife plan...
|
|
8 |
1,217 |
|
|
2003 Windshield Replacement...HELP! by
2003HondaEXL
My front windshield needs to be replaced. The Honda dealer tells me that
there are two windshields for my car...one is $350 (made in USA) and the
other one, which is "recommended" according to my VIN is $850 (made in
Japan). I have searched high and low to verify what they are telling me
is the...
|
|
6 |
1,217 |
|
|
'91 Honda Accord SE radio/ tape player by
[email protected]
A few months ago I bought a CD player at Best Buy. They took out the
tape player/ radio that came with my '91 Honda Accord SE (very similar
to a LX) and installed a CD player. Today, at my request (and at
no-charge as part of the original installation charge), they took the
CD player out and...
|
|
0 |
1,217 |
|
|
Is my engine too hot? by
[email protected]
89 civic. Is my engine too hot? After 10 min driving, park it and
open the hood and all I feel from is "damn it my engine too hot"
Today I picked up the oil dip and checked the oil. It was so hot I
drop the dip stick. Definitely the end of the stick was hot.
Do you think this is normal? I remember...
|
|
2 |
1,216 |
|
|
Yokohama Avid Ascend tires for 2009 Accord? by
David E. Powell
My dealer just replaced my tires for my 2009 Accord with Yokohama Avid Ascend 225/50 R17s.
My older tires were Michelins, and besides tread wear had cracking in the surface of the rubber. The service guy said the Yokohamas might be a bit more resistant to road salt induced surface cracking....
|
May 21st 14 01:40 PM
by News
|
1 |
1,214 |
|
|
stupid crank pulley bolt by
disallow
OK I know its been posted like 1000 times, but I seriously
think that my pulley bolt is damaged or something, cuz no
matter what I do, it won't budge. So far I have tried:
1. 650ft/lb impact wrench with chain wrench and some
rubber belt wrapped around pulley to prevent it from
spinning. I broke...
|
|
3 |
1,214 |
|
|
'89 civic - no electrical at all, but sporadic! by
CAS
Hello group,
I have an '89 Honda Civic with 156k miles. Have owned it since '91 and
40k miles. I have seen a _very_ sporadic electrical problem since at
least '96, but it was at the once-a-year level, so I haven't done
anything about it. Here it is:
Sometimes, the car acts like the battery is...
|
|
4 |
1,213 |
|
|
'90 accord ecu codes 1 & 43 (fixed) by
Vlad Ciubotariu
Hi All,
My mechanic checked the fuel pressure (code 43) and found nothing wrong.
So we went to replace the O2 sensor with OEM and check engine light is now
gone. The car also `seems' to me to have better acceleration and smaller
rpms at high speeds.
My symptoms were a few random losses of power...
|
March 24th 07 03:26 AM
by Tegger
|
3 |
1,213 |
|
|
Comment on car insurance by
Useful Info
*My consumer experience*
I've had insurance with Allegiance, Geico, Traveler's, and now Erie.
Geico was expensive. I knew I was paying for their prime-time TV ads.
I paid something like $1200 per year.
Traveler's was cheaper. I assumed it was the cheapest in town.
I paid $920 per year.
( 1 2 3 ... Last Page)
|
July 8th 07 03:04 AM
by newman
|
46 |
1,213 |
|
|
Hello Again... I'm back.... by
StephenW
Been out of the newsgroup thing for a while, I moved from a desktop computer
to a laptop, and have difficultied getting the laptop to read news groups
when both at work (wifi) and here at home (dialup).
Anyway, I left Firestone a year and a half ago and have been working at a
Subaru dealership....
( 1 2 3 ... Last Page)
|
|
38 |
1,212 |
|
|
Accord 99 Clock and Temprature LCD Back Light, by
George Kinley
Greetings ALL
My Accord's Clock and Temprature Back light is not working, I called up
the mechanic and asked the price for fixing it , he is asking 100 $ for
the work , what is your opinion regarding this price. One more
Information that all the other interior is working fine,
|
|
3 |
1,212 |
|
|
91 Civic Ignition coil by
Sean
Hi,
Can someone tell me the primary and secondary ignition coil resistance
specifications for 91 Civic STD HB?
I am having intermittent starting problems. I checked the ignition coil and
I got the following readings:
Primary: 0.08 Ohms
Secondary: 12K Ohms
Is it possible that the ignition coil is...
|
|
1 |
1,211 |
|
|
H23 conversion? by
VAMP MADNESS
I have a stock h23, and was wondering what it would take to make it
Vtec?? Could I just swap out heads and the computer and make sure the
computer is set for the 2.3 lt? or is it more involved than that?
|
|
0 |
1,210 |