|
|
|
|
14 |
1,077 |
|
|
What to do If a dealer does a bad alignment. by
chris777 via CarKB.com
I will try and keep this simple, as I have seen some similar post, but I
had a few specific Questions.
here are the details before the questions
I have an 01 honda crv, I Put new tires on It at around 59k approximately 2
or 3 days after purchacing it.
I got a good deal on micheline hydroedge at...
|
|
5 |
1,077 |
|
|
The Best Car in World Today by
Lucern
The Best Car in World Today
Trully the best and fastest sedan I have ever owned. Any sedan in the
mid 50s that can get from 0-60 in 5.5 seconds in my book is far above
average. My 535 handles extremely well and performs every bit as well
as advertised. I highly recommend this car to any one. I am...
( 1 2)
|
|
17 |
1,077 |
|
|
|
|
14 |
1,077 |
|
|
2001 Jeep Grand Cherokee Limited AC fans not blowing by
[email protected]
I've got a 2001 Jeep Grand Cherokee Limited 4.7L 8 CYL SOHC MPI 4 DR.
WAGON/SPORT UTILITY.
The AC seems to be working fine, but the fans aren't coming on so the
cold air isn't blowing out. I had somebody work on the AC before and I
think they messed up the wire harness that is below the dash...
|
|
0 |
1,077 |
|
|
I rounded the bleeder screw - what now? by
bryanska
Hi,
I bled the brakes in my 2002 Alero yesterday, for what I plan is the
only time. I'd like to know the bleeding process I'll have to follow,
now that I have to replace one bleeder screw.
Two of the bleeder screws were rounded in the process. I used a flare
nut wrench specifically designed for...
|
|
3 |
1,077 |
|
|
Getting fuel line compression fittings leak free by
Ed
The FI return line attaches to the fuel tank with a 5/16" compression
fitting that I
can't get a good seal on. I even replaced the tube section and of
course used a
new compression sleeve. I've tightened it quite a bit, but it still
weeps. It so little that
it probably wouldn't matter if it were...
( 1 2 3)
|
|
22 |
1,077 |
|
|
Affordable Japanese Used Cars by
[email protected]
Are you looking for an inexpensive used and new car in Japan? Look no
further. SBT Japan is one of the automobile companies that provide
excellent and satisfying services in the field of cars industry. They
provide many types of cars that you can choose from such as BMW,
Porsche, Mitsubishi,...
( 1 2)
|
|
17 |
1,076 |
|
|
Alternator ? (Excessive Voltage) by
Doc Holliday
I've got a 19861/2 Nissan pu d21. The other night my son and I were
driving home and discussing a voltage problem and doing a little fild
experiment trying to figure it out. The home stretch he decides to run
the RPMs up probably around 6,000 and waualla we blew both hig beams.
Now this wasn't a...
( 1 2 3)
|
|
20 |
1,076 |
|
|
Somebody finally gets it small turbo diesel in the USA by
bob
http://www.technologytell.com/in-car-tech/3655/honeywell-turbochargers-help-chevrolet-cruze-clean-turbo-diesel-post-fuel-economy-estimates-of-46-mpg
Now, if GM can get over the covered 350 diesel stigma time will tell
bob
( 1 2)
|
|
12 |
1,076 |
|
|
|
|
17 |
1,076 |
|
|
Buying a '92 BMW 535, worried about failing emissions by
Ulf
Hello,
I'm in the market for a used car and today I looked at a very nice '92
BMW 535. However, when the owner showed me the papers from the last
safety inspection I noticed the car was very close to failing emissions.
It had a HC reading of 98 PPM, with max allowed being 100 it was only
*two* PPM...
( 1 2)
|
May 2nd 05 12:20 AM
by Ulf
|
19 |
1,076 |
|
|
Using 20 mm Narrower Tires ? by
Bob[_53_]
Hello,
Have been offered a set of 4 brand new tires.
Unfortunately, the size isn't exactly what my car came with.
The offered tires a 205/60-16
My car came with: 225/60-16 (2009 Buick LaCrosse)
So, I guess my Buick normally has 20 mm wider tires, but the same for
( 1 2)
|
|
18 |
1,075 |
|
|
1988 Crown Victoria: Slipping in Overdrive by
PastTense
I have a 1988 Crown Victoria with a 5.0 engine--with 110,000 miles on
it.
A few days ago when I stopped the car wouldn't go into reverse. After
a while of shifting through gears, shutting the car off, restarting
reverse suddenly started working again. I drove it 20 miles to my
mechanic. He found...
|
|
8 |
1,075 |
|
|
Cruise Control Slow Turning On Odyssey 98 by
Ted Leja
We bought this 98 Odyssey with 2.3 litre VTEC used last year and added
about 20,000 kilometers to it and she now has about 166,000 with a
recent timing belt change at our local Honda dealer last week. I
believe that the switch fits all previous generation Accords
1998-2003. I asked them to test...
|
|
0 |
1,075 |
|
|
|
|
2 |
1,075 |
|
|
oil and knock from rocker arms/lifters by
Morris[_2_]
have a question regarding oil and type as related to a knocking from either
the rockers arms/lifters/springs
when using a 20W-50 castrol gtx type oil, until engine is really warm, I can
hear the sound
when I use a 0W-30 synthetic type oil, the noise disappears pretty quickly,
before engine is...
( 1 2 3)
|
|
27 |
1,075 |
|
|
2001 Cadillac Deville Stalling Problem by
Bernie17125
Can't seem to keep my 2001 Cadillac DeVille from stalling. Starts
every time, but starts stalling after running for 10-30 minutes, then
stalls more frequently when the engine is warmed up. Had car towed to
GMC Dealer. Dealer experienced same problem - stalled when moving it
from their service lot...
|
November 3rd 19 02:51 AM
by Xeno
|
9 |
1,075 |
|
|
|
|
2 |
1,074 |
|
|
Heater hose replacement by
Jon C
http://www.partsamerica.com/ProductDetail.aspx?mfrcode=DAC&mfrpartnumber=300122&parttype=1066&ptset=A
http://tinyurl.com/bt2t4
This hose assembly on my 98 Grand Am is leaking at connection B.
Instead of replacing the entire assembly at $62, I was thinking of
simply cutting away the upper hose (A...
( 1 2)
|
|
14 |
1,074 |