|
|
|
December 31st 05 10:01 PM
by R. P.
|
2 |
545 |
|
|
TDC mark not on flywheel where expected by
[email protected]
A while ago I put a new clutch in my '82 NA 1.6L diesel VW Rabbit. Is
it possible I put the flywheel back on wrong? Now that I'm doing the
timing belt, I've hit a problem. I have the oil pan off so I can see
when the #1 piston is at TDC according to the crank, but there is a
mark on the flywheel...
|
|
3 |
468 |
|
|
camry v6 balljoint removal: advise needed from a tech by
davemac
I'm in the process this weekend of replacing the front lower control
arms on my wife's 93 v6 xle camry. The old rear rubber bushings (large
2" dia) of each of the existing control arms is torn and I think it is
the source of some creaking noise she is hearing. The new control arms
came with new...
|
December 31st 05 05:11 PM
by davemac
|
0 |
523 |
|
|
|
|
0 |
542 |
|
|
help! 1997 Hyundai Accent, gear grinding by
bri j
Someone from rec.autos.driving sent me here - so this is crossposted:
I just bought a 1997 Hyundai Accent (5 speed/manual trans, 136k miles)
and it's got a few kinks (as I expected, with that many miles). I'd
like to have a better idea of what's going on before heading to the
mechanic, although...
|
|
3 |
492 |
|
|
Req: OTC 3800 Vision Lab Scope Info. Read in. by
I bought a used Vision Scope a while back which didn't have any manuals with it. I was wondering
if anyone may a have an idea where a guy could get a manual or a copy of one . I've searched
everywhere I can think of on the internet without any luck.
Although I'm actually a motorcycle/marine...
|
December 31st 05 03:25 PM
by
|
0 |
471 |
|
|
83 Rabbit Steering Column Repair by
N8N
a cheezy fix is to shove the retainer back up there and put a zip tie
below it. I may or may not have done this on my old daily driver VWs a
few times <G>
nate
|
December 31st 05 01:09 PM
by Huw
|
3 |
758 |
|
|
Honda "Drive by Wire" question... what if the power goes out? by
David E. Powell
Hi there.
I have been looking at the new Honda Civic, it's pretty sweet, and the
welds and everything are as nice as anything I have ever seen. I just
have a question about the "Drive by wire" system that they are supposed
to have.
What happens if the Engine dies on you? In my current car, my...
( 1 2 3 ... Last Page)
|
|
230 |
10,914 |
|
|
4 wheel drive problems by
chubbychop
i have a 2003 ford ranger and this is the first year i have used the 4X4 on
it is all electronic no lock outs or anything like that. well today i used
the 4 wheel because i had to go through a wet feild not too muddy just wet
well afterward i went to put it back into 2 wheel drive and it just made...
|
December 31st 05 12:53 AM
by boxcar
|
6 |
848 |
|
|
Auto Immobilizer/Door opener Defense Pak re-code by
RB
Hello,
Anyone know how to re-code a Defense Pak remote. The controller is three
button type, top button -lock and immobilize, middle button- one click
driver;s door open- second click all open. bottom button-boot open.
/ sequence etc
I understand that there is a sequence of using ignition key to...
|
December 30th 05 11:37 PM
by RB
|
0 |
415 |
|
|
|
|
0 |
632 |
|
|
|
|
0 |
589 |
|
|
Grand Cherokee rollover transmission failure by
[email protected]
Please help!
Just rolled over my brother's 2003 Grand Cherokee in the snow. Half
over that is. Managed to get it back on its feet, but the wheels no
longer turn, in any gear (it's an automatic of course)
He needs to get back to work in 2 days...
I wondered if it could be a rollover sensor, and...
|
December 30th 05 05:35 PM
by N8N
|
4 |
460 |
|
|
Down with Sylvania by
Dave M.
I bought a set of H1 SilverStars. Installed them without touching the bulbs.
After almost 3 months the left bulb blew as soon as the headlamps were
turned on. I returned the lamps for a replacement. After about 2 months both
bulbs blew simultaneously when turned on. The car is an Acura RSX-S....
( 1 2 3 ... Last Page)
|
|
44 |
1,920 |
|
|
|
|
2 |
381 |
|
|
|
|
17 |
847 |
|
|
Grand Cherokee rollover transmission failure by
[email protected]
Please help!
Just rolled over my brother's 2003 Grand Cherokee in the snow. Half
over that is. Managed to get it back on its feet, but the wheels no
longer turn, in any gear (it's an automatic of course)
He needs to get back to work in 2 days...
I wondered if it could be a rollover sensor, and...
|
|
0 |
359 |
|
|
Delco 10SI, how much noise? and other questions by
N8N
Just curious, is it normal for a Delco 10SI to make an audible noise
while running? I have tried two different units in my '55 Stude and
both are somewhat noisy. One is the one that was in the car when I
bought it. The other is a reman that I believe to be of dubious
heritage, as when I...
|
December 30th 05 01:59 AM
by N8N
|
7 |
494 |
|
|
1994 Aerostar will not start by
soccermomsoccer
My 1994 Aerostar just recently will not start all the time. It began when
I let it get almost completely empty. It was hard to start. I put dry
gas in it and it started all the time for a few days then one day it was
below 1/2 tank and it would not start. Later in the day it started. Now
it...
|
|
4 |
423 |
|
|
|
|
9 |
937 |