A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Technology Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Alternative to Trichloroethane by Wan A. Cat
I'm considering installing a fiberglass spoiler to my car, so I read the manufacturers installation instructions to see if I can do it myself. It seems feasible, but the instructions left me with one question. They say to scrub the fiberglass with 1,1,1,trichloroethane to clean off the "release...
(Multi-page thread 1 2)
January 13th 06 09:11 AM
by Go to last post
19 949
urgent by brucie
I have a vauxhall astra 1.4i '96 and need to know the torque settings for the head bolts i wold be gratfull if anyone could help me please
January 13th 06 07:17 AM
by tNt Go to last post
1 382
Roger Galvin's 'Colortune' method by [email protected]
I ran across mention of this as an accurate method to analyze exhaust. What is it? Thanks in advance.
(Multi-page thread 1 2)
January 13th 06 04:06 AM
by Paul Hovnanian P.E. Go to last post
13 844
Power steering noise 95 olds cutlass ciera by ANTHONY DIODATI
We have this 95 olds cutlass ciera in the shop with a Power steering noise, just like it was low on fluid. Fluid level is fine though. We replaced the pump, and same problem. My manager thought the rebuilt pump might be bad, so we replaced it a 2nd time. Same noise. The car steers fine too, just...
January 13th 06 01:23 AM
by ANTHONY DIODATI Go to last post
5 559
1998 mazda protege hard to start after sitting for more than 20 mins by [email protected]
I have a 1998 mazda protege that has real trouble starting the first engine i had had a blown head gasket so i replaced the engine now the new engine is doing the same thing it seems that after the vehicle sits it looses compression but when you can get it to start it runs awsome????Any ideas??
January 12th 06 09:08 PM
by [email protected] Go to last post
8 416
Anyone rebuilt a tranny? by Help!
Anyone rebuilt a tranny? A standard tranny? How hard? Is it a matter of disassemby, check, replace worn out parts and reassemble? Thank you. Bryan
(Multi-page thread 1 2)
January 12th 06 07:26 PM
by xblazinlv Go to last post
13 782
stupid little part... by Nate Nagel
does ANYONE know where I can get a banjo fitting for the inlet of a Carter AFB that has an inverted flare (5/16" or 3/8") rather than a 3/8" hose barb? Trying to neaten up my underhood, but there seem to be only two options, either to buy the really expensive line from Russell with AN fittings, or...
January 12th 06 06:57 PM
by Brian Go to last post
4 452
95 Grand Cherokee Rough Idle/Stalling by [email protected]
Greeting, My HIGH mileage (220k) '95 Grand Cherokee (4.0L automatic) is occasionally idling rough and the rpm's will drop to a near stall just after coming to a stoplight, and sometimes stumble just as I'm taking off again. All of this is under normal driving conditions, no hard breaking or...
January 12th 06 03:50 PM
by [email protected] Go to last post
9 544
Double lay shaft by [email protected]
can anyone tell me what is double lay shaft in gearbox is it one more lay shaft in gearbox, then more drive can be select? whhich types of vehcile used it?
January 12th 06 03:01 PM
by [email protected] Go to last post
2 654
Tie Rod replacement by Jpw
When replacing tie rods, to what length should they be adjusted to? I have a 97 Chev Suburban C1500 2WD in particular.
January 12th 06 12:52 AM
by Go to last post
7 651
heater core damage from power flushing by jackl
I have had two vehicles, a Saab 900turbo, and a Chrysler Cirrus, which both developed heater core damage within a month of power flushing the cooling system. Could the two be related? In the latter case, the Dodge dealer replaced the heater core under warranty and now there is a very foul smell...
January 12th 06 12:22 AM
by Huw Go to last post
9 428
spark plug on a S10 Blazer 2002 by bluemarble
how do you get the center plug out on the drivers side? need help soon as I can get it.
January 11th 06 08:47 PM
by bluemarble Go to last post
1 315
Help,!!flush brake fluid or replace all brake parts!!! by pinfun
Went to our cheap tire store and had a brake check.Do we need pads?fluid?NOOOO You might as well junk that 93 astro van because of contaminated brake fluid,you need $1700 to replace all rubber parts in brake system.We are not rich and cannot put $1700 in a 93 van thats really a nice ride...
January 11th 06 08:06 PM
by [email protected] Go to last post
4 869
Mercury Capri 1991 by ozymandias
I have a Mercury Capri 1991 convertible. The car was owned by someone else briefly before I got it, but who ever had it, probably put motor oil in the place where transmission oil should go. My probelms started with the transmission when I tried to change the transmission fluid, then the...
January 11th 06 05:36 PM
by Alex Rodriguez Go to last post
2 364
Engine stopped due to radiator leakage by [email protected]
The engine of my Corolla stopped and fumes were coming from the hood. The oil temperature was high, but not too high. The car was fixed because it was the garage's fault for not properly fitting a tube. My question is: can this cause any permanent damage?
January 11th 06 05:29 PM
by Alex Rodriguez Go to last post
2 230
1991 Chev truck engine knock by CL (dnoyeB) Gilbert
brian wrote: > (Meyer) wrote in message >... > (brian) wrote in message >... >> >>>I need some help. I have a 91 chev truck with a...
January 11th 06 05:28 PM
by CL (dnoyeB) Gilbert Go to last post
0 440
Engine stopped due to radiator leakage by [email protected]
The engine of my Corolla stopped and fumes were coming from the hood. The oil temperature was high, but not too high. The car was fixed because it was the garage's fault for not properly fitting a tube. My question is: can this cause any permanent damage?
(Multi-page thread 1 2)
January 11th 06 04:41 PM
by Steve Go to last post
14 591
moisture proofing ignition? by William R. Watt
Any suggestions on moisture proofing an ignition system? Yesterday it stalled at a light when cold and was missing after it warmed up. I took it home and wiped down the ignition wires, distributor cap, and coil. Runs fine now. I had to wipe it down last summer too. The car sits in the garge most...
(Multi-page thread 1 2 3)
January 11th 06 03:56 PM
by Go to last post
25 1,131
Advanced Tech by PLENI SELENE
HOW FAR TECHNOLOGY MOVES FROM TALK TO ROBOTS, Would you Like To Know How The Electronic Devices Understand When You Talk to Them, And How It Works To Speak Spanish? Because spelling words and names are common in English, Software have been developed to code names based on how they sound....
January 11th 06 02:28 PM
by PLENI SELENE Go to last post
0 854
2000 Ford Windstar won't move: by Kenny
Hi a buddy has a 2000 Ford Windstar 3.8L with 75,000 miles on it and it will not move in any forward gear selected, only reverse. The automatic transmission fluid appears clean and full, and the transmission was serviced at the 60,000 mile interval. Any ideas what could be wrong here? Thanks, Bush
January 11th 06 11:40 AM
by Pat Go to last post
2 411
Post New Thread


Display Options
Showing threads 11801 to 11820 of 16938
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 10:36 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.