|
|
Throttle position sensor by
Bob Nogueira
I was driving my wife's Nissan Cube and noticed that on occasions when stopped with engine running, depressing the throttle resulted in no increase in engine RPM until the petal was about 1/4 to 1/2 fully depressed, once past that mark the engine would suddenly rev quickly to what you would expect...
|
|
1 |
240 |
|
|
P0171, P0174 and scan tool readings by
micky
I have a 2005 Toyota Solara SLE, 133,000 miles, with P0171 and P0174
codes, lean mixture in both banks, and a check engine light that returns
soon after being cleared.
I've cleaned and then replaced the MAF sensor, replaced the PCV valve,
and listened all over for hissing. I have a constant...
( 1 2)
|
|
10 |
417 |
|
|
Need to buy a transmission jack for a Tacoma clutch - HF has a sale - advice? by
harry newton
I need to buy a transmission jack for a Tacoma clutch.
How heavy is a W59 Toyota Tacoma transmission anyway?
I this 800# jack (on sale until the end of the month) good enough?
<https://www.harborfreight.com/800-lb-low-lift-transmission-jack-69685.html>
Does the 33% cheaper scissor-jack have any...
( 1 2)
|
October 30th 17 07:13 PM
by Tekkie®
|
15 |
660 |
|
|
|
|
3 |
287 |
|
|
Genset voltage reg: capacitor vs. AVR by
Existential Angst[_2_]
What are the pro's/cons of each?
One pro for caps is that they are cheaper! The AVR ditty for my unit would
cost another near-$400.
The pro for AVR is, presumably, much tighter voltage regulation with load.
But mebbe AVR has its limits ito ruggedness?
The voltage swing on my genset is 250 -...
( 1 2 3 ... Last Page)
|
|
75 |
4,187 |
|
|
Q45 won't start (cranks easily) how to diagnose? by
Paypaul
replying to Alora Duncan, Paypaul wrote:
97 Q45 won’t start and I don’t hear the fuel pump I need to know where the
fuel relay and control module is located
--
for full context, visit http://www.motorsforum.com/nissan/q45-won-t-start-cranks-easily-how-to-diagnose-12482-.htm
|
|
8 |
867 |
|
|
Why is my 1985 s 10 2.8 engine so hard to start ? by
[email protected]
Ok,i have been searching for an answer to why my truck is so hard to start. I have done everything i know to fix this but no luck yet . I have put a re-manufactured carburetor on it.I have checked all the vacuum lines,replaced the fuel pump. manual pump. I have a clear fuel filter that look good. I...
( 1 2 3 ... Last Page)
|
|
50 |
1,519 |
|
|
Warm daah before taking it apart? by
micky
I have to remove the air vents above the radio in the middle of the dash
tomorrow, on a 2005 Toyota.
I tried today several times and the bezel or whatever bent without
breaking, but the thing popped back where it was originally.
I'm worried about cracking or breaking the plastic. Today was...
( 1 2)
|
|
10 |
433 |
|
|
2010 Pontiac Vibe problem by
Percival P. Cassidy[_2_]
Not my own car: posting for someone else.
2010 Vibe (mostly Toyota components) was running very rough and
vibrating. "Trusted mechanic" said it's running on only two cylinders,
it's not an ignition or valve or head problem, but something -- he can't
figure out what without taking it apart, and...
|
|
5 |
261 |
|
|
|
|
0 |
208 |
|
|
Catalytic converter by
Molly Brown
I live in Southern California. I replaced the catalytic converters on my truck and have been looking for a place to sell the old ones to compensate my cost of $800.00 I paid for the new one. If I can’t find a place willing to give me some money for it I will be trashing it. Can anyone give me...
|
October 16th 17 01:59 AM
by micky
|
7 |
472 |
|
|
Tire Question From Sr. Citizen by
Bob[_53_]
Hello,
Thanks again for previous help. Very nice of you all.
Sr. Citizen now, so please bear with me a bit.
Have to get new tires for my 2009 Buick LaCrosse (4 door sedan)
Live outside of Boston. "Fair" amount of snow in the winter.
I leave my tires on all year round, even though I agree it's...
|
October 16th 17 01:53 AM
by micky
|
2 |
439 |
|
|
Directional And Asymmetrical Tire Designation(s) by
Bob[_53_]
Hi,
On a tire that is both Asymmetrical and Directional, how would they
likely be marked for mounting ?
Just a simple arrow showing rotational direction ?
(no Inside or Outside designations)
Or, the arrow for the correct rotational direction, AND the
Inside or Outside designation on the...
|
October 15th 17 07:53 PM
by Retired
|
1 |
334 |
|
|
Grom Audio, adding USB and Bluetooth to your car radio by
micky
I'm thinking of installing a Gromaudio device that, if your car radio
has a CD changer input jack, allows for USB input, AUX input from a
cellphone, and for another $50 Bluetooth use of the cellphone through
the car speakers and an add-on microphone (in addition to the first
$150).
The most...
( 1 2)
|
October 15th 17 04:36 PM
by micky
|
10 |
908 |
|
|
Fuel Pump Timer? Pump Location? by
Nehmo
I successfully changed the fuel pump on my 2001 Ford Ranger 3.0L 126"
wheelbase, flex-fuel truck . But I have some unanswered questions,
and they'll plague me the rest of my life if they remain so.
Is there a fuel pump timer? How does it work, and where is it?
If indeed, the pump is cooled by...
( 1 2 3)
|
|
22 |
1,514 |
|
|
Head light by
Kowshik
I have Nissan Sentra GXE 1999. recently my headlights are not properly
working. whenever i light up normal light it is quite dim. but my high beam
works well.It has seperate bulbs for high beam and normal beam. how can i
solve this Please help
--
for full context, visit...
|
|
6 |
772 |
|
|
Mixing Of Tires Question by
Bob[_53_]
Hello,
Thanks for previous help and info.
Great group.
Nothing is ever simple, I guess.
Have a 2009 Buick LaCrosse
Live in Boston. Get our share of snow and ice, but nothing like
northern Maine or Minn.
|
October 4th 17 01:23 PM
by Xeno
|
1 |
437 |
|
|
Tire Wear Question ? by
Bob[_53_]
Hello,
Have a 2009 Buick LaCrosse.
Using Michelin all-season tires; do not change them
out over the summer.
About 40-50 K on them now.
I noticed the front two tires have "considerably" more wear on them than
the rear.
|
October 2nd 17 12:22 AM
by Xeno
|
4 |
503 |
|
|
|
|
3 |
263 |
|
|
Help ! purge air after coolant change by
[email protected]
On Friday, January 18, 2002 at 9:26:24 AM UTC+10, Jack wrote:
> Hi group,
>
> I have a 1993 mazda 323 1.6L. Have just put a new radiator and two new
> heater hoses on it. I was told that I should purge air out of the
> system after I fill it up with coolant again.
>
> The problem is I couldn't...
|
|
1 |
244 |