I parked the '67 Toronado outside jusat before the temperature got below freezing about a month ago. It was above 50 degreees, so I decided to drive it today. It started right up, just needed some power steering fluid. It ran fine all day, but started hesitating on the way to work tonight. It...

Hi: I've been trying to figure out why a Mercury Sable 89 vehicle is leaking power steering fluid where it has to be filled up every day to every other day. It has a 3.0 V engine. The leak looks like it's leaking right above the exhaust pipe. Could this be the line above it? Also, if it is,...

I have a 1995 Jeep Grand Cherokee which the turn signal has came apart. The part that turns the wipers on/off has came off the turn signal lever. I still have the spring that was inside and there is still a pin through the brass rod that the piece that fell off went over but I can't get the parts...

Does anyone have any tips for removing oxidation from vinyl dashes? Thanks

Hi, This question makes me feel like an idiot.but I really need an answer. On my Dads 1985 Mercury Grand Marquis we needed to change the rubber on the drivers side wiper. The local stores do not sell the rubber replacements any more so I picked up the entire head assembly from Wal-mart. However...

I have inherited my daughters '97 Geo Metro LSI and it is in really good shape except for the dash which has badly oxidized from sitting in the Florida sun from grey to almost white. Is there anything that can be done, short of replacing it, to remove the oixidation? Suggestions will be very...

I just finished a rebuild on the engine of a 93 mx-3 1.6L engine, rebuilt the head only, not the block. But how when im trying to set the timing, i cant get it below 8 degrees of timing advance and the engine idles high (1500 rpm) the distribuiter is allthe way cranked to one side, and i cant...

> wrote: > I've also read there are two methods - the patch and the plug. > > Any comments and prices? Ironically, my recommendation is the patch/plug. It is one large patch that has a conical rubber "plug" molded to the center and perpendicular to the patch surface. ...

Does anyone know how to change timing belt on Mercury Villager '96? I just wonder how difficult it is to do it? I've done a lot simple work on my car but nothing that serious like changing timing belt.

The daytime driving lights stay on even when the 97 Taurus is turned off. The high beams do not seem to work either and the highbeam indicator is on when the headlights are off. Any ideas???

Does anyone have an interchange manual handy? Need to know what seats would fit my son's 92 S-10 pickup? Many thanks.

Photo shows a properly chocked wheel, when vehicle is raised on lifting devices. http://www.jumbojoke.com/safety_last_my_friend_jack_374.html

I have a '91 Geo that has almost 200k miles on it. Still runs great and I'm about to replace the front struts. However, I have noticed a lot of play in the front end and especially on grooved highways. I thought that it was cause by worn front control arm bushings for maybe a bad ball joint. I...

This is one person's testimony: I drive a 2005 Toyota Solora. I normally get 22 mpg in the city. On my last fill up using the powder, I got 33.2 mpg in the city!! I love the powder, and wouldn't be without it! Also, I always have to fill up every 5 - 6 days, but I was able to go an extra 3...

Anyone know if the Borg Warner E71P ignition coil needs a ballast resistor? Thanks, Sam

I removed the dash on my '96 Jimmy to fix a heating problem.. replaced the dash and all the plugs and whatnot, the thing started right up and no engine light.. all the lights work and windows etcetera, however.. with key off turning on the lights displays the turn signal arrows on (both of them,...

Hi: I've been having some major problems with a Mercury Sable 89 vehicle...before it was just the power steering fluid leaking out...now it's got it so that it has to really rev up before changing into the next gear. I've tried checking the transmission fluid and it's filled past the point where...

Can Imron be mixed to match a desired color?

Aftermarket Manual indicates to just pry this large Dash Center trim panel out of hidden recessed retaining clips to access heater control panel screws to access rear of this control panel to change bulbs. Center trim panel seems very tight and is also around ignition switch, has anyone here...

I have a 1987 Nissan D21 Pickup 3.0 v6 - 5 speed. The engine will not rev up past 3000 RPM's without cutting out. It runs fine below 3000 RPM. I have to shift to the next gear in order to drive and keep under 3000 RPM.This started after truck was in flood water up to the seats (had to replace...