A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Technology Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
GMC Pickup Switch by [email protected]
I need to install a multi-function or "Combination switch" for the the wipers/turn signal etc. on my 98 GMC 1500 Pickup. I have had several friends tell me that I don't need to try this my self because of removing the airbag etc. The switch itself doesn't look too bad. Any suggestions about...
January 21st 05 04:25 AM
by Daniel J. Stern Go to last post
2 409
Looking for Pontiac Acadian 1978 service manual by Kenny MacInnes
Does anyone out there have a service manual for the Pontiac Acadian (1978)? Ken
January 21st 05 06:10 PM
by Jonathan Grobe Go to last post
3 956
Nissan Truck Clutch Master Leaks by Jim
I have a 1988 Nissan 2WD 2.4L truck with the master clutch cylinder leaking. Can the clutch master cylinder be rebuilt? Are there kits available and how difficult is it? Would I be better off to just replace the master cylinder with a new one? What's a good brand? All recommendations are...
January 21st 05 06:24 PM
by Billy Bad Assr© Go to last post
3 469
rusty discs - how rusty is normal? by ant
a few months ago i switched out the entire front brake system- heavily scored discs, beat pads, and frozen calipers were replaced with cheap autozone discs and pads, and rebuilt calipers. now, if i dont drive every day, the disc surfaces rust visibly, and make an obvious grinding noise the first...
(Multi-page thread 1 2)
January 21st 05 07:10 PM
by ant Go to last post
16 1,274
HELP!! by [email protected]
I have a 98 4runner limited and I am having the exact same hesitation you are talking about. I can rev the engine from the engine compartment and there is almost a sec delay before the engine revs. Also there are times during acceleration the engine runs smooth and then sometimes it sputters. I am...
January 21st 05 08:09 PM
by [email protected] Go to last post
0 320
Intermittent stall 92 Century by KENG
Arggg I'm so flustrated...... Car: 92 Buick Century, V6, 3.3L, 161K miles Problem: Stalls intermittently, no stumble prior, it just stops. Like the key was turned off. No codes are stored. All the warning lights come on when it stops. Usually it will restart fine. Sometimes it well restart...
(Multi-page thread 1 2 3 ... Last Page)
January 22nd 05 03:03 AM
by aarcuda69062 Go to last post
50 2,438
shutting off overdrive on a 97 Wrangler by Stephen Early
"Stephen Early" > wrote in message ... > Howdy, > > I have a 97 Wrangler 4.0 with an automatic and I want to put a switch on the > dash so I can turn off the overdrive easily. Has anyone done this or have > ideas? I was...
January 22nd 05 04:06 AM
by Stephen Early Go to last post
0 527
Salvage car write-off by Martik
I considering to resell a 2003 CHRYSLER Sebring purchased from a Manitoba insurance company for $3800CAD. It was a write-off due to some electrical system problem after the trunk portion was lowered into a lake and has been repaired. There is no visible damage to the car which only has 20k kms....
January 22nd 05 04:22 AM
by Martik Go to last post
6 547
Lumina runs hotter than I think it should... by RobGute
Hi, I have a 93 Chevy Lumina Euro... it is the W Frame car (like the olds, and about 3 others) I have the 3.1, and it has the type of cooling system where it uses the 2 electric fans. When crusing, most of the time, the car runs right where it's supposed to, at 180-190 degrees... but at slower...
January 22nd 05 08:06 AM
by gobroncos Go to last post
2 675
!997 Mercury Sable CamShaft position Sensor by NevadaSable
My 1997 Sable has a wierd problem. MIL light On, The only Code P0340 stored scanned at autozone. Problem Intermitant no shift out of 1st, and no overdrive. I understand how the ECM not understanding or getting RPM info could cause shifting issues, I would think if I had Transmission solenoid...
January 22nd 05 11:46 PM
by NevadaSable Go to last post
5 1,569
highest psi creatable by hand-crank mechanism? by [email protected]
What are the commercially available mechanisms/devices that would allow creation of very high levels of hydraulic pressure by human movement? Bicycle type of mechanism is preferred. I'm already familiar with the Enerpac product line. Anything goes to higher levels?
January 23rd 05 05:10 AM
by tomcas Go to last post
8 846
Ford Dealer or AAMCO or? by NevadaSable
I posted earlier on 1997 Sable Cam sensor Thanks to all in the group. My issue is a very intermitant no shift out of first and no over drive. I live in Reno Nevada and wonder if the ford dealer or a local tranny shop would be better for cost and ability to fix this rather funky issue. I thought...
January 23rd 05 09:54 AM
by [email protected] Go to last post
4 577
83 Chevy Truck running rough/missing by hawkeyes2
I would appreciate some ideas of what my truck's problem might be. It runs great when starting up and runs fine for the first mile, but then it starts to bog down and miss. If you pump the gas pedal/goose it a little bit it jumps like it wants to run, but it doesn't sustain it. It's an 83...
(Multi-page thread 1 2)
January 23rd 05 10:00 AM
by Ted Mittelstaedt Go to last post
14 1,251
the gear lever clicks after putting in park by [email protected]
car is 94 accord. automatic trans. This could be a problem, but need your input. Problem: After I move the gear lever from Drive to Park, it takes about 4 seconds later that I can hear a loud click sound coming from the gear lever. It sounds as if the gear isn't locking or something until 4 ...
January 23rd 05 12:50 PM
by Anthony Go to last post
1 393
Can someone identify this sound? by JM
I've got a 99 Nissan Altima with an odd sound to it while accelerating. It's a regular thrumming, sort of "fluttery" sound. My 94 has a very similar sound as well, but a bit more harsh I think (due to less sound deadening maybe), so it could very well be normal. I'd really like to know what...
(Multi-page thread 1 2)
January 23rd 05 03:24 PM
by Lawrence Glickman Go to last post
10 1,699
Hood won't shut tight by Larry
The hood on my '99 Subaru Legacy won't close tight. You can't open it without moving the release tab on the hood, but it won't "lock down". Driving at 60mph on the hghwy, it bounces up and down a bit. Is there any danger of it coming loose and flying open? Thanks
January 23rd 05 03:28 PM
by JM Go to last post
5 704
Going reverse with engine off (did I ruin my car?) by ozone
Without turning the engine on, I put it in reverse (it's an automatic) and rolled down the driveway a bit to... I really can't remember. It is probably a REALLY stupid thing to do. Ever since then my car can barely start (it acts like the idle is really low,) but adjusting the idle doesn't seem to...
(Multi-page thread 1 2)
January 23rd 05 06:22 PM
by Daniel J. Stern Go to last post
14 1,379
Check engine light after GM 3.8 recall ( fuel rail / regulator ? ) - Code P0171 by [email protected]
The day after I took my 1998 Olds Delta 88 in to a local metro Atlanta ( Buick/Pontiac/GM dealer for the fuel rail / regulator recall in my check engine light came on . I had it scanned and got the Code P0171 ( The fuel system of bank 1 was too lean "). Was this jut a co-incidence and not related...
January 23rd 05 06:27 PM
by Steve Mackie Go to last post
1 802
Jibberish by Lawrence Glickman
On Mon, 17 Jan 2005 13:07:49 -0500, John Caffrey > wrote: >Someone please track down and prosecute this perverted lower life form. >jc You can't. Somebody, I think "backyard mechanic" in alt.autos.ford says this crap is coming from Hong Kong. How he knows that, I dunno, but...
January 23rd 05 09:43 PM
by Dev Null Go to last post
6 612
Times Have Changed: Cold Starting by Daniel J. Stern
On Thu, 20 Jan 2005, Steve wrote: > > Near universal use of 5W-30 oils and more common use of synthetics. > > (10W-40 used to be the most common oil used). > Nope Actually, Steve, yeah, that is one of the factors in the much greater ease of super-cold starts. You live in Texas. I live in...
(Multi-page thread 1 2)
January 23rd 05 09:44 PM
by Steve Go to last post
19 1,242
Post New Thread


Display Options
Showing threads 1881 to 1900 of 16938
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 10:26 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.