|
|
1967 Olds Toronado died on the drive home by
Mr. DOS
I parked the '67 Toronado outside jusat before the temperature got
below freezing about a month ago. It was above 50 degreees, so I
decided to drive it today. It started right up, just needed some power
steering fluid.
It ran fine all day, but started hesitating on the way to work tonight.
It...
( 1 2 3 ... Last Page)
|
December 29th 05 03:46 AM
by Mr. DOS
|
33 |
1,494 |
|
|
Power Steering Fluid Leak - Mercury Sable by
[email protected]
Hi:
I've been trying to figure out why a Mercury Sable 89 vehicle is
leaking power steering fluid where it has to be filled up every day to
every other day. It has a 3.0 V engine. The leak looks like it's
leaking right above the exhaust pipe.
Could this be the line above it? Also, if it is,...
|
December 29th 05 01:48 AM
by clifto
|
1 |
557 |
|
|
Turn Signal Lever Problem by
[email protected]
I have a 1995 Jeep Grand Cherokee which the turn signal has came apart.
The part that turns the wipers on/off has came off the turn signal
lever. I still have the spring that was inside and there is still a pin
through the brass rod that the piece that fell off went over but I
can't get the parts...
|
|
2 |
466 |
|
|
Restoring dashboard by
sumtimes
Does anyone have any tips for removing oxidation from vinyl dashes?
Thanks
|
|
2 |
640 |
|
|
|
|
3 |
720 |
|
|
Oxidized dashboard by
sumtimes
I have inherited my daughters '97 Geo Metro LSI and it is in really
good shape except for the dash which has badly oxidized from sitting in
the Florida sun from grey to almost white. Is there anything that can
be done, short of replacing it, to remove the oixidation? Suggestions
will be very...
|
|
2 |
491 |
|
|
93 Mazda mx-3 idles high after rebuild by
[email protected]
I just finished a rebuild on the engine of a 93 mx-3 1.6L engine,
rebuilt the head only, not the block.
But how when im trying to set the timing, i cant get it below 8 degrees
of timing advance and the engine idles high (1500 rpm) the distribuiter
is allthe way cranked to one side, and i cant...
|
|
4 |
270 |
|
|
How much to fix a flat these days? by
Comboverfish
> wrote:
> I've also read there are two methods - the patch and the plug.
>
> Any comments and prices?
Ironically, my recommendation is the patch/plug. It is one large patch
that has a conical rubber "plug" molded to the center and perpendicular
to the patch surface. ...
( 1 2)
|
December 27th 05 08:56 PM
by *
|
12 |
848 |
|
|
Mercury Villager timing belt replacement by
carlos
Does anyone know how to change timing belt on Mercury Villager '96? I
just wonder how difficult it is to do it? I've done a lot simple work
on my car but nothing that serious like changing timing belt.
|
|
1 |
490 |
|
|
Taurus daytime driving lights by
Ron
The daytime driving lights stay on even when the 97 Taurus is turned off.
The high beams do not seem to work either and the highbeam indicator is on
when the headlights are off. Any ideas???
|
|
1 |
549 |
|
|
Seat for 92 S-10 by
Scott Dudley
Does anyone have an interchange manual handy? Need to know what seats
would fit my son's 92 S-10 pickup?
Many thanks.
|
|
0 |
180 |
|
|
Safety First by
Moe
Photo shows a properly chocked wheel, when vehicle is raised on
lifting devices.
http://www.jumbojoke.com/safety_last_my_friend_jack_374.html
|
|
1 |
589 |
|
|
GEO front spindle retention? by
Steve
I have a '91 Geo that has almost 200k miles on it. Still runs great and I'm
about to replace the front struts.
However, I have noticed a lot of play in the front end and especially on
grooved highways. I thought that it was cause by worn front control arm
bushings for maybe a bad ball joint.
I...
|
|
1 |
418 |
|
|
WANT BETTER FUEL MILEAGE - LOOK NO FURTHER! by
Don
This is one person's testimony:
I drive a 2005 Toyota Solora. I normally get 22 mpg in the city. On
my last fill up using the powder, I got 33.2 mpg in the city!! I love
the powder, and wouldn't be without it! Also, I always have to fill up
every 5 - 6 days, but I was able to go an extra 3...
( 1 2 3 ... Last Page)
|
|
40 |
1,404 |
|
|
|
|
7 |
441 |
|
|
Jimmy turn signal problem not yet covered.. by
[email protected]
I removed the dash on my '96 Jimmy to fix a heating problem.. replaced
the dash and all the plugs and whatnot, the thing started right up and
no engine light.. all the lights work and windows etcetera, however..
with key off turning on the lights displays the turn signal arrows on
(both of them,...
( 1 2)
|
|
13 |
1,352 |
|
|
Mercury Sable 89 by
[email protected]
Hi:
I've been having some major problems with a Mercury Sable 89
vehicle...before it was just the power steering fluid leaking out...now
it's got it so that it has to really rev up before changing into the
next gear.
I've tried checking the transmission fluid and it's filled past the
point where...
|
|
2 |
616 |
|
|
|
|
3 |
375 |
|
|
'97 Camry/Avalon Question on Dash Center Trim Panel removal by
Frank Knight
Aftermarket Manual indicates to just pry this large Dash Center trim panel
out of hidden recessed retaining clips to access heater control panel screws
to access rear of this control panel to change bulbs. Center trim panel
seems very tight and is also around ignition switch, has anyone here...
|
|
1 |
522 |
|
|
RPM Problem Nissan Pickup by
Truett
I have a 1987 Nissan D21 Pickup 3.0 v6 - 5 speed. The engine will not rev
up past 3000 RPM's without cutting out. It runs fine below 3000 RPM. I
have to shift to the next gear in order to drive and keep under 3000
RPM.This started after truck was in flood water up to the seats (had to
replace...
|
|
1 |
453 |