|
|
|
|
2 |
384 |
|
|
Electronic Ignition Wiring by
ZhangLu
Trying convert the breaker point system to electronic ignition for my
Landcruiser II 1991 model with 22R engine. The electronic ignition
comes with the whole distributor with one blue and one black wire.
There are no other wires.Can anyone advise me how should I connect the
wires?
|
|
3 |
876 |
|
|
Timing belt followup. by
B.B.
I asked a few days about changing a timing belt. For anyone curious,
here's how it all went.
Started off, I decided to take a little peek at my timing belt one
day, so I popped off the top of the belt cover. The belt was in
horrible shape, looked like it was about to shred. I decided I...
|
April 2nd 06 06:39 AM
by B.B.
|
6 |
1,231 |
|
|
Mazda protege 94 fuse diagram by
[email protected]
Hi,
I can not turn on my headlights on my Mazda protege. I guess it must
be a fuse by I do not have an owner's manual so I am not sure which
fuse to replace. I have been replacing fuses at random but that did
not solve my problem. Does anyone have a link to a protege's fuse box
diagram or might...
|
|
1 |
372 |
|
|
FA 1998 Chevy & GMC C/K Truck Service Manual SET (ALL4) by
Rick2950
1998 Chevy & GMC C/K Truck Service Manual SET (ALL4)
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1,1&item=8052058353&sspagename=STRK%3AMESE%3AIT
Ebay Seller: dewmanm
THESE BOOKS ARE CHEVROLET/GMC C/K TRUCK SERVICE MANUAL 1998.
ALL FOUR VOLUMES. THE BOOKS ARE IN GREAT CONDITION....
|
|
0 |
916 |
|
|
95 Mercury Cougar - EGR Bad? by
Libby Chantel
95 Cougar, 4.6 V8, 120,000 miles
My check engine light came on after the car had just been sitting for a
couple of weeks. I got Auto Zone to read the code, which turned out to
be something about the EGR valve. Does this actually mean the valve
itself is bad, or just that a sensor SAYS it is bad?...
|
|
5 |
590 |
|
|
2001 Dodge Caravan Gas Pedal Sticking by
Joy Suyehara
Frequently, the gas pedal will stick as I'm driving. I can be cruising
on the freeway and when I want to accelerate, the pedal will be hard to
push. Eventually, I can get the pedal to work, but it is scary. The
pedal can also be hard to push after the car has been setting for a
while....
( 1 2)
|
|
10 |
572 |
|
|
95 Continental Tech Serv Bulletins, More, Special Offer !!! by
[email protected]
95 Cont Tech Serv Bulletins, More, Special Offer !!!
Just the other day I purchased a year's subscription for complete
technical service bulletins and more (see link below) and found them to
be quite helpful--it is only for the 95 Continental. As a service to
other members, I would be glad to share...
|
|
0 |
611 |
|
|
TV Antenna Signal Wire by
klara
Looking to put TV antennas in the trunk lid behind the liner...
so I need to route the signal wires to tuner in front.
Should I keep the signal wire(s) away from other electrical harnesses
to avoid "distortion" ?
I'm not sure if I should route the wire along either side of the car,
where there is...
|
April 1st 06 02:10 AM
by ed
|
9 |
527 |
|
|
Automotive Electrical Problem by
[email protected]
Hello everybody, I'm a pretty smart guy when it comes to electronics,
which can make me very dangerous. I have a problem with my 1989 Chevy
S-10 Blazer that I need some help with. Here's the deal...
About 4 or 5 months ago, I started to notice that the battery wasn't
holding a charge, and...
( 1 2 3)
|
March 31st 06 11:55 PM
by clifto
|
21 |
915 |
|
|
How to Plug this hole in Oiling System? by
Caprice85
I'm looking for a suitable plug to use in a Nissan Sentra to block flow
of oil into the oil filter bypass hole in the engine block. This is the
hole which is covered by the oil filter, and allows oil to bypass the
filter, under certain conditions. This hole is supposed to have a
valve in it but...
|
March 31st 06 11:16 PM
by
|
6 |
505 |
|
|
|
March 31st 06 09:08 PM
by Shep
|
1 |
552 |
|
|
OBD-2 Code P0106 for my Mazda by
RS
Greetings, I recently ran the OBD code reaqder on y 1999 Mazda protege
and received the error code P0106.
THe description in the book said it is, "manifold Absolute
Pressure/Barometric Pressure Circuit Range/Performance Problem"
Does anyone know what this means?
Thanks for your help.
RS
|
March 31st 06 08:13 PM
by M.M.
|
6 |
851 |
|
|
Should I change my starter when doing timing belt? by
[email protected]
I have a 2000 Mazda Protege ES with 105k miles
I'm the original owner. Bought it brand new
anyway I'm way over due to have the timing belt changed
and plan to have dealer do it next week
I will also have dealer replace water pump, etc
Do you think with such high mileage I ought to have em
( 1 2)
|
|
14 |
647 |
|
|
|
|
0 |
453 |
|
|
|
|
0 |
610 |
|
|
|
|
0 |
778 |
|
|
E32 Driver Door wont open from the outside after being locked. by
criii
I have a strange problem with a driver side door on a 91 735i.
Scenario:
1. Lock doors using the key
2. Unlock doors using the key
3. Driver side door won't open from the outside.
I can open it from the inside and then it will open fine from the
outside. But once I lock it it won't open from the...
( 1 2)
|
|
10 |
703 |
|
|
|
|
0 |
397 |
|
|
|
|
0 |
727 |