|
|
|
|
10 |
1,069 |
|
|
distributor cap catched fire by
tss212
I have a 1989 GMC C1500 350 TBI. Has new distrubitor. Also has msd
a6L. i was driving on highway about 60 mph for about 20 minutes,
stopped at driveway and truck died. I seen smoke coming from under
hood. I opened the hoood and the distruibutor cap was on fire. It was
an accel cap and rotor. I dont...
( 1 2 3)
|
June 26th 07 12:37 AM
by tss212
|
25 |
1,068 |
|
|
Electrronic keys- a rant by
Don Stauffer
Ah, for the good old days when all my keys would fit in a keycase. I
had found that leaving keys loose in my pocket wore holes in the
pockets, so long used a key case.
The keys for my last two cars are electronic, and WAY to big to fit in a
key case. My Prius key is all-electronic (no...
( 1 2)
|
June 21st 09 01:56 AM
by HLS
|
16 |
1,068 |
|
|
Problem with clutch - bad smell.....Any ideas? by
[email protected]
Hi -
I own a 2000 Suzuki Grand Vitara (and have owned it for over two
years). Recently, it has started to emit a really bad burning smell
immediately after riding the clutch a bit (like when I am pulling out
of a parallel parking spot on a hill).
My car NEVER did this before and just starting...
( 1 2)
|
|
13 |
1,068 |
|
|
|
|
21 |
1,068 |
|
|
Wheel alignment - how do I know they really fixed it? by
[email protected]
My question is pretty much summarized in the subject line.
So, you drop off your car at a tire shop for wheel alignment. How do
you know they really performed the service? They may have not even
touched your car, then gave you some bogus alignment reading printout.
1-2 weeks later the tires are...
( 1 2 3)
|
August 15th 05 05:59 PM
by Steve
|
23 |
1,068 |
|
|
|
|
1 |
1,068 |
|
|
Please help me with a 1960's GM Delco 10DN Alternator & external regulator. by
LowEnergyParticle
I need some help on a GM charging system, being used on an old Allis
Chalmers FP40 forklift. The Allis uses an old Delco Remy 10DN
alternator, which has an external regulator. The wiring harness and
original electro-mechanical regulator were torn out by vandals.
The local NAPA store sold me a...
|
|
0 |
1,068 |
|
|
Buying a '92 BMW 535, worried about failing emissions by
Ulf
Hello,
I'm in the market for a used car and today I looked at a very nice '92
BMW 535. However, when the owner showed me the papers from the last
safety inspection I noticed the car was very close to failing emissions.
It had a HC reading of 98 PPM, with max allowed being 100 it was only
*two* PPM...
( 1 2)
|
May 2nd 05 12:20 AM
by Ulf
|
19 |
1,067 |
|
|
Mazda 2 (2011) front brake replacement by
Jc Maxwell
So this weekend some friends and I are going to attempt replacement of front rotors and pads on a 2011 Mazda 2 Sport.
I took the car to a mechanic a while back. He reported that there was a lot of rust on the rotors, and the pads had very little (perhaps 5%) material left. The rust is likely the...
( 1 2 3)
|
|
20 |
1,067 |
|
|
Tempo/Topaz front motormount / swaybar help please by
[email protected]
Greetings,
I am doing my first '89 Tempo/Topaz motor mount replacement. It's the
one under the battery/airbox on the drivers side. I have removed the
rubber part, but cannot get a good grip on the three 13mm bolts that
hold the top metal half to the automatic transmission. My tools are all
either...
|
|
1 |
1,067 |
|
|
VW Dune Buggy issues... by
rdoc
Please follow this one for a bit:
I'm working on a newly acquired chopped down VW Beetle Dune Buggy. Not a
pro job... obviously some guys in a backyard did it.
It's a 70 chassis with a 69 Solex 30 PICT 2 carb on a 1600 74 motor.
It runs a little sluggish and then the throttle
picks up...
( 1 2)
|
July 13th 06 04:11 PM
by jim
|
15 |
1,066 |
|
|
Seat position sensor for airbag, 2005 Scion tC by
Hachiroku $B%O%A%m%/(B[_2_]
So a few months ago (August or so) I replaced the stock Scion seat with a
seat from a Celica. Made the car a bit more comfortqable and easier to
drive. However, the Celica seat did not have a position sensor for the
airbag, so since then I have been driving with ther airbag light on.
Since...
|
|
4 |
1,065 |
|
|
69 Manx sputtering by
[email protected]
I have a 69 Manx with a fresh 1915cc that I built last year. So when the engine was built I used an empi progressive carb and I can’t install the heat risers because my exhaust doesn’t have the port for them. I believe that my sputter may be caused by condensation building up. How can I get...
|
|
1 |
1,065 |
|
|
1973 chevy pickup v8/350 Rochester quad carb by
knitey
I bought this truck for my 13 year old to learn about engines. When we
got the truck, it would start if you primed the carb, run for awhile
and die. So far, we have:
Rebuilt the carb
Replaced plugs and wires
dist. cap and rotar
points
oil/filter
fuel pump
put in an inline fuel filter
( 1 2 3)
|
August 15th 06 02:39 PM
by N8N
|
21 |
1,064 |
|
|
Soon speeding will not be possible... by
Steve W.
http://www.americanprowler.org/dsp_article.asp?art_id=9327
Make Speeding Impossible?
By Eric Peters
Published 1/26/2006 12:07:35 AM
Like tearing off that sticker on mattresses that warns us not to "under
penalty of law," most of us don't pay much attention to speed limits.
Five to ten over is the...
( 1 2 3)
|
|
25 |
1,064 |
|
|
Daniel Stern was right again... by
N8N
On the recommendation of a poster to a Porsche forum I frequent, I
bought some LED dash light bulbs for my 944. Haven't tried those yet
but on a whim, I also bought a pair of 1157 style LED bulbs for the '55
coupe, just to see if I could a) get some more light out of my
taillights and b) reduce...
( 1 2 3)
|
November 8th 05 10:46 PM
by Steve
|
22 |
1,064 |
|
|
Hard downshift 94 Chrysler T&C auto trans by
Al VaBeach
It is noticeable when our 1994 T&C van 2wd with 88,000 miles down
shifts to 1st gear. We never noticed this before and lately it seems to
down shifts hard to 1st. When I say hard, it's like a clunk sound. When
the other gears down shift, it is not that noticable...very smooth.
Other than than, no...
|
|
7 |
1,064 |
|
|
Anyone have an 05 Escape with poor mileage? by
Finite Guy
Hi All: Just wondering if anyone here has a Ford Escape and gets
crappy fuel economy. I recently posted here about this. Any statistics
anyone has is greatly appreciated.
I have an 05 Escape Limited and my wife does mostly city driving.
Fuel economy is very poor. 147. - 15.0 mpg.
The dealer wants...
( 1 2)
|
|
12 |
1,064 |
|
|
Zero lash Cont. by
Rojo2G
As recomended I TDC'd each cylinder(chey 6 cycl.) and tightened out the play on
the pushrod, plus about 5/8 rev. on the nut. I rotated the engine by hand and
rechecked the play. Most had play again so I repeated the tightening a second
time. I spun the engine once more and still had to tighten a...
( 1 2)
|
|
12 |
1,063 |