|
|
'94 Acclaim -No Headlights in Freezing Weather by
Gary Kaucher
The headlights on my '94 Plymouth Acclaim won't work when the outside
temperature is below freezing. But they do work when the temperature rises
above freezing. All the other lights and electrical components work fine
regardless of the temperature. Any suggestions appreciated.
Gary
|
|
1 |
650 |
|
|
92 Lexus ES300 v6 Oil Leak by
sdcbh
Toyota / Lexus Techs please help...
I've been working on sealing up oil leaks on a '92 es300 (3VZFE v6).
So far I've replaced both front and rear value cover gaskets and
distributor o-ring.
Now I hope I'm down to the last leak.
It is where the "?oil filter housing?" meets the block.
I'm not sure...
|
December 11th 05 09:56 PM
by sdcbh
|
0 |
640 |
|
|
TRANSFORME R$6,00 EMR$6.000.000 EM POUQUISSÍMO TEMPO!!!!! by
taca
Método aprovado pela revista EXAME TRANFORME R$6,00 EM R$6.000,00 EM
POUQUÍSSIMO TEMPO Método aprovado pela revista exame!! Leia o texto
com
atenção; funciona mesmo! É só seguir as instruções abaixo Eu não
acreditava, e já estou recebendo.Sabe porque vale a pena?O
investimento é
irrisório,R$ 6,00...
|
|
1 |
574 |
|
|
paintless dent repair, Los Angeles by
JT
Being a poor dude I bought a used Avalon from Hertz.I was happy with
myself until my wife pointed out the dents I'd missed. A couple on the
hood, even a blind man should have been able to see, and after his
wife pointed them out, they seemed to take on a brilliant glow that
caused people from miles...
|
|
1 |
221 |
|
|
Truck runs too cool - how to diagnose the problem? by
Libby Chantel
96 Chevrolet 4.3L V6 C1500
This is a continuation of the Thermostat thread I had started earlier:
http://groups.google.com/group/rec.autos.tech/browse_thread/thread/58f6f4e5e054165a/fbae8f5686c7cfb2#fbae8f5686c7cfb2
My truck runs too cool. I have installed a new 195 thermostat and
tested it by...
|
|
9 |
607 |
|
|
2000 Grand Am 3.4 Cutting out by
[email protected]
I had problems with this some time ago and there were several
suggestions
for the problem, first and foremost being a "dirty fuel filter" . The
fuel filter was
replaced, although when one understands just how fine the screen filter
is on
the pump it's difficult to understand how a filter this...
|
|
5 |
246 |
|
|
98 Camry Knock at Rear Wheel by
spunky1
I have a knock at the passenger side rear wheel on my 98 Camry. The
knock does not occur on all bumps but it sounds like something is loose
or broken. I've looked underneath several times now and can't seem to
locate the problem. The rear struts were replaced about 2 years ago at
Sears. Any...
|
December 11th 05 01:42 PM
by spunky1
|
4 |
466 |
|
|
Please help with a UseNet survey by
Director
If you are man at least 18 years of age the Millikin Project on Social
Perceptions invites you to participate in a study of users of selected
UseNet/NetNews groups.
The survey will take about 10 minutes and will help us understand the usage
patterns, opinions, and experiences of NetNews users.
|
December 11th 05 01:12 PM
by
|
2 |
727 |
|
|
|
|
2 |
462 |
|
|
Coolant leak advice needed... by
Pete C.
Now that it's cold and miserable to work on my truck, it's decided to
start a slight coolant leak that appears to be coming from the block
heater port (a.k.a. freeze plug if no block heater).
It's just a modest drip and would probably not be an issue if left for
warmer weather except for the fact...
|
December 11th 05 02:39 AM
by Bob
|
6 |
584 |
|
|
poor electrical connection by
[email protected]
Hello,
I have all ready read other posts but I am not sure where I can buy
"copper grease" or "dielectric" here in Canada so I thought I would
make my own post.
Last summer I replaced the windshield washer pump because the old one
stopped working. When I installed the new one I couldn't get the...
( 1 2 3 ... Last Page)
|
|
32 |
1,513 |
|
|
Carburettor question by
[email protected]
I have a Ford Festiva with a carburetted 1.3L engine. The engine needs
a carb producing about 140 CFM to run it. I have no idea what the CFM
the stock carburettor is rated for, but it runs the 1.3L engine fine.
My plans are to replace the engine with a 1.6L engine that normally
takes 170 CFM to...
|
December 10th 05 11:04 PM
by
|
7 |
589 |
|
|
Push button car starter by
[email protected]
In the past few years, push button car starter appear to arrive in some
car models. The Lexus GS 430, and the new IS350 has one of those.
Mercedes Benz shows their new cars using a key fob. So does the new
Infiniti M series. Are both technologies the same?
Who (which car company) started the push...
( 1 2)
|
December 10th 05 07:03 PM
by Don.
|
19 |
1,169 |
|
|
2001 Dodge Grand Caravan - Transmission Control Module? by
[email protected]
The check engine light came on in my 2001 Dodge Grand Caravan. I took
it into the shop today (it's under a third-party warranty), and was
told the "Transmission Control Module" was bad.
>From my research (and I don't know much about cars, forgive me), this
is a computer unit on the outside of the...
|
|
8 |
1,021 |
|
|
2004 Suzuki Forenza by
bri_cin
What is "Speed sensitive power assisted steering"(ssps)? And how do I use
the feature, and not use the feature? Or is it automatically activated?
|
|
1 |
527 |
|
|
Serpentine Belt goes bad too soon. by
Sam Nickaby
I've been having trouble with premature belt failure for a while and can't
figure this out. The first belt that came with the car had a section of it
chipped off. The belt caused a knocking sound on the pulleys and was
removed. I'd checked the idler pulley and they spin smoothly. I'd installed
a...
( 1 2 3 ... Last Page)
|
|
43 |
2,500 |
|
|
Mazda 323 by
bri_cin
need help with the timing procedures. Timing marks etc.
|
December 10th 05 04:13 AM
by
|
4 |
370 |
|
|
'94 buick park ave, delco radio stuck in station scan, fix ? by
Rob B
trying to see if anyone is familiar with this problem ?
the original radio (Delco) is stuck in station scan mode ?
yes, scan is off, there is a little SC in display that goes on and off when
you cycle the scan button but radio still scans
Is there a way to disable the scan feature by modifying...
( 1 2)
|
December 10th 05 01:04 AM
by Richard
|
10 |
1,030 |
|
|
How long should tie rods last? by
Chuk Goodin
We just had the front passenger side tie rod break on our 99 Chevy
Venture. There are only 66K km on it -- isn't that kind of soon? Haven't
hit anything.
--
chuk
( 1 2)
|
|
10 |
637 |
|
|
loose cylinoid by
gal-luvin-cars
my 89 chevy corsica has loose cylinoid how dangerous is this
|
|
2 |
234 |