|
|
Turning rotors on a shop lathe by
Proctologically Violated©®[_2_]
Awl --
First, how "rough is rough" before you have to turn down a rotor?
In the two rotors I just took off, one face was quite smooth, two faces were
smooth but a little "ridgy" or ripply, and one was obviously scored and
gouged. Is ridgy/ripply OK?
Next, the rotors fit quite well on a 13"...
( 1 2)
|
April 20th 09 12:24 AM
by HLS
|
10 |
511 |
|
|
Cruise control (after-market install) by
Ivan Vegvary
I'm trying to install an after-market cruise control system (Audiovox
CCS-100) on a 1995 Toyota Tercel. I know it's not much of a car, but, we
use it as our run-around vehicle and it does get an honest 33± miles per
gallon.
Question:
I would sure like to install it within the driver's reach. ...
|
|
1 |
245 |
|
|
Loose MAP sensor? (Cavalier) by
George[_23_]
('99 Cavalier, 2.2L)
The car is showing an intermittent TPS 'low voltage' code. When I went
to look at the TPS, I noticed that the MAP sensor (right below the TPS
on the throttle body) is loose: it rotates around with negligeable
force.
The (MAP) sensor doesn't seem to be screwed in or...
|
|
2 |
261 |
|
|
Need advice on a multimeter by
Mike S.
I'm a newbie when it comes to auto repairs. I plan on buying a
multimeter but I'd rather start out with something simple and
inexpensive. I figure I should work my way up to more expensive
multimeters like the Flukes. I'm just not sure I'm going to be all
that interested in auto repairs. No sense...
|
|
7 |
555 |
|
|
sell fresh cvv by
[email protected]
i want sell cvv
US master n visa : 2$ per 1 Us discover and amex: 4$ per 1
Uk randam: 5$ per 1, uk with dob: 25$ per 1, uk bin 15$ per 1, uk bin
with dob 50$ per 1
Eu: some country but always have italy : visa and master , france,
germany, and holland-polland
If u want buy u can contact to me by...
|
|
0 |
256 |
|
|
Corolla misfire after sitting one day by
Dan[_6_]
95 Corolla, 4A-FE with 100k miles. When first started in the morning,
after not being driven for 1 day or more, it seems to misfire (like
running on 3 cylinders) for about 10-20 seconds. After that, the
engine smooths out and runs normally.
When the car is in daily use, it starts and runs OK.
What...
|
April 17th 09 08:01 PM
by jim
|
7 |
338 |
|
|
Another Rustproofing Question by
Chris F.
I posted a message a while ago, regarding the best lubricant for
rustproofing the interior of various car body cavities. I decided to go with
Rust Check, which is commonly available here in Canada and comes highly
recommended. But today I discovered that there are two different grades of
this...
|
|
3 |
219 |
|
|
2000 Dakota update (Head experiment) by
stryped[_2_]
Well, I did an experiment last night:
I took one of the heads (the one with the suspected blown head gasket)
and turned it over on its side the the exahust ports on top. I sprayed
brake cleaner in the ports to fill them up with fluid. Every exhaust
valve seeped fluid out of it, eventually...
( 1 2)
|
|
11 |
797 |
|
|
Mercedes Ignition problems by
Doc
1990 300 E mercedes auto with ignition tumbler / key install where the
ignition key cylinder was rebuilt by the dealer and having trouble
reinstall .> Will not fully seat into the housing. Any ideas?
|
April 17th 09 01:44 PM
by Doc
|
0 |
201 |
|
|
Question on Jags by
[email protected]
Question on Jags
*******************************
I am not knowledgeable on car audio systems at all.
I have a few questions:
1. What has a greater impact on the sound quality of a car audio
system ?
Is it the speakers or the sound unit ie CD changer/player/radio ?
|
|
5 |
257 |
|
|
2000 Dakota another update by
stryped[_2_]
I was digging through paperwork on this truck and found the Midas
ticket. Aparently in November my brother took the truck in becasue of
no heat. They noted there was antifreeze in the truck but the
protection was only to 5 degrees. The flushed the cooling system, then
"pressure flushed" the heater...
|
|
2 |
337 |
|
|
Considering buying a new F350 in the next few weeks... by
Pete C.
I'm considering buying a new F350 in the next few weeks, F350, diesel,
4x4, DRW, probably a manual transmission.
New 2009 or perhaps leftover 2008 model. Is there anything in particular
to watch out for on these models?
Thanks,
Pete C.
( 1 2)
|
|
16 |
1,208 |
|
|
saving gas by following another car by
liu
http://www.gassavers.org/showthread.php?t=2584
I can seem to find more info on this technique. I tried on highway but
I really don't know the distance between 2 cars. I would never
tailgate but maybe 4 or more car distance. It's not easy when driving
at 60 - 65mph as most cars pass mine than me...
( 1 2 3 ... Last Page)
|
|
30 |
1,669 |
|
|
1998 Lincoln passive (coil spring) strut replacement by
Steve Walker[_1_]
Me again. Another brother problem. ( remember the 95 f-150 with shifting
problems.?) He likes Fords. <G> He has a 1998 Lincoln Continental with a
broken spring in the front strut. We got another, but can't get the
strut out. 3 bolts on top are off. Pinch bolt is out and strut moves up
and down...
|
|
0 |
244 |
|
|
235/55R17 tires on 2005 Town Car Signature Limited? by
The Derfer[_2_]
The dealership said to stick with the 225/60R17 tires the car's
"supposed" to have.
The overall diameter is very nearly the same. But the dealership said:
* The whole 10mm of extra width would cause the tires to hit the
suspension on
wide turns.
* They also said "If the car has traction control...
|
April 15th 09 05:45 AM
by fred
|
9 |
391 |
|
|
2000 Dakota update and further advice (Head gasket) by
stryped[_2_]
Well, been working on this v6 2000 3.9 l Dakota that my brother said
overheated and started blowing white smoke. I have the heads off and
wanted to make some comments and get some advice:
1: This is the first time I have worked on a dodge. I thought the
distributor would need to come out in order...
( 1 2 3)
|
April 14th 09 10:52 PM
by HLS
|
21 |
1,004 |
|
|
Cleaning coolant sludge from engine by
ray
1990 Chev K1500. 350, somewhere around 240,000km. (odo broke years ago...)
intake gasket failed and I got coolant in the motor - everywhere. Truck
ran rough, stalled. Chocolate milk in the oil pan.
What we did:
Changed oil and filter. Yum.
Pulled distributor, hooked up priming tool and...
|
|
7 |
352 |
|
|
Unusual 3.8L Intake Manifold Leak? by
snuckfoe
1996 Buick Regal, 83K miles, 3.8L NA engine. Thought I may have
had the characteristic problem with the EGR tube warping the Upper
Intake Manifold. But the leak instead APPEARS (see pix links) to be
originating from the front, not the rear, of the engine, possibly where
a right-angled black plastc...
|
|
9 |
2,108 |
|
|
OBD-II code readers: Listen when your car speaks by
Ablang
http://www.andybrain.com/archive/obdii-code-reader.htm
OBD-II code readers: Listen when your car speaks
You're standing next to someone and they suddenly yelp "technology!"
What would you think? First, you should back away slowly. After you're
safe, avoiding eye contact, you'd think, "Technology....
|
April 14th 09 03:14 PM
by Ablang
|
2 |
761 |
|
|
Problems with 95 Jeep Cheroke by
m
My 95 Jeep Cheroke makes a weird noise when I stop. I originally
thought the noise was coming from the rear brakes but they were
repaired and the noise didn't go away.
Sounds like a weird rubbing /squeaking noise from underneath and the
sound occurs at the instant that the Jeep comes to a complete...
|
April 14th 09 02:27 AM
by m
|
5 |
388 |