I'm installing a remote starter in a 95 jeep cherokee, manual transmission. The system has a reservation mode that requires a connection to a wire that shows negative when the parking brake is engaged. Any ideas what color that wire would be, where it would be located, or a suitable negative wire...

Hello, My Jeep autotrans is not working right now. When we start the car it runs fine until you hit 2nd gear and then it doesn't run smoothly and doesn't change gears. The reverse works fine. If you wait for 5 minutes and start going again it runs fine again. I don't know anything about cars. ...

I have a 1995 Jeep Wrangler with a 2.5 liter 4 cyl. auto. Begining several months ago, I had problems starting it. The problem in the begining almost seemed climate related. The Jeep would not start in the AM. As the afternoon came around the jeep would always start. It didn't take long to...

Bad metal to metal sound coming from passenger side rear wheel each time wheel rotates to a certain position. When brakes are applied the noise stops. Comments or suggestions?

Light began coming on in dash cluster about air lift--back end is in "up" position, can't seem to get it to go down, even with switch turned off. What should we be looking at--solenoid/switch problem, compressor problem, or ???? Thanks!

Light began coming on in dash cluster about air lift--back end is in "up" position, can't seem to get it to go down, even with switch turned off. What should we be looking at--solenoid/switch problem, compressor problem, or ???? Thanks!

I had a mysterious stalling problem with a Plymouth Sundance . After a couple of years and many parts replacement I found that the rubber grommet in the gas tank was disintegrating and the small particles of rubber were clogging up the filter in the fuel pump. Has this problem been seen in...

Over the past year, I have had an intermittent CEL 0104 (vehicle speed sensor), along with 0504 (a/t control) and 0304 (knock sensor). The speed sensor checked out, plus my speedometer was functional. My guess was that the signal path from the speedo head to the ECM was intermittent. I was able...

Okay, this car runs great but everythime I start up, the RPMs shoot to 2500 then it settles down to 1350 after the initial warm up. Suspecting a vacuum leak, I have checked all hoses an they all look good. I also did the WD40 thing with no luck. I read on here somewhere that if I disconnect the...

Hello, My girlfriend has a 1995 Mercury Sable GS with Overdrive Transmission. We don't use overdrive around town because we have both heard people say using it for town (stop and go) driving stresses it and to only use it on the freeway and on long trips. I have also heard it is ok to use...

Hello, My girlfriend has a 1995 Mercury Sable GS with Overdrive Transmission. We don't use overdrive around town because we have both heard people say using it for town (stop and go) driving stresses it and to only use it on the freeway and on long trips. I have also heard it is ok to use...

I am trying to determine the cause of a rough running 1995 Mustang GT 5.0 HO (150K miles). The owner (who is inexperienced with engines) had powerwashed the engine and then replaced the distributor cap, wires and plugs. The engine runs like hell. I swapped the wires back to the 13726548 firing...

Hey All, Need some advice again. I have a 1995 mustang gt, 5.0L, ~90k miles that, all of a sudden, runs hot according to the in dash temp gauge. 4 years ago I replaced the ECT and all hoses, belts, coolant and thermostat (180 degree unit). Never had a problem with overheating and it never got to...

1995 nissan altama gxe (no break lights) i checked the break light switch, fuses, bulbs. can it be the third break light bulbs out? would this cause break lights to fail? i have running lights and signels. please help!

It's been doing this for about 7,000 to 10,000 miles now, but this is the worst it has been. My truck is a 1995 Nissan Hardbody with a 2.4L, 4-cylnder, manual transmission. (Just incase that helps.) What it's doing: In neutral and only in neutral the engine stops, uhh, working. The engine stalls....

I think that my Quest needs a new TIME CONTROL MODULE which controls the interior lights. The lights won't turn off when you shut the door. I 've been told that it is a black and green box about 3X5X1" and is under the dash on the drivers side. I can't find it. I even went to the junk yard and...

How do I get past the plastic or rubber seal at the firewall in order to remove the the intermediate steering shaft lower pinch bolt? I need to do this so I can separate the intermediate shaft from the steering gear. I cannot push the seal far enough out of the way to gain access and get a wrench...

I have 1995 Cutlass with the Electronic Climate Control. One day the heat/AC system worked fine, but the next time I went to use it, I discovered that when I run the heater/AC fan at medium to high speed, I get a loud vibration/rumbling sound coming from inside the dash. At low fan speed, I get...

I recently got a used 1995 Park Avenue Ultra seemingly in decent general condition. The driver's power seat controls don't work, but the front passenger seat works fine. The side-view mirror controls don't work. The driver's seat heater and the driver's recliner control also don't work, but...

While looking for the cause of my 1995 dodge ram van 3.9liter vans hesitation I checked the throttle position sensor.The voltage is supposed to vary between about 1/2 to 5 volts depending on throttle position but at wide open throttle I'm getting 0.2 volts DC.Supply voltage is at 5 volts and...