stripping paint from flares
whoever painted my flares did a crap job and they are peeling. Does anyone
know any decent non-abrasive products that will strip paint from plastic without destroying it? thanks Jason |
hit it with a pressure washer
"Pi-Eyed Piper" > wrote in message news:mFRDe.140106$9A2.126677@edtnps89... > whoever painted my flares did a crap job and they are peeling. Does anyone > know any decent non-abrasive products that will strip paint from plastic > without destroying it? > > thanks > > Jason > > |
It's peeling but not that much. I have blasted it, not much comes off.
"IsellJeeps" > wrote in message ... > hit it with a pressure washer > > > > "Pi-Eyed Piper" > wrote in message > news:mFRDe.140106$9A2.126677@edtnps89... >> whoever painted my flares did a crap job and they are peeling. Does >> anyone >> know any decent non-abrasive products that will strip paint from plastic >> without destroying it? >> >> thanks >> >> Jason >> >> > > |
Pi-Eyed Piper did pass the time by typing:
> It's peeling but not that much. I have blasted it, not much comes off. I'm not aware of any paint strippers that don't melt plastic. Possibly call your local auto repair/repaint folks or paint supply store and ask. They might have something new. Careful application of heat and a soft pine scraper, but generally the best approach is to wet sand and repaint. If it's real nasty you might need to sand down to the base plastic. If your not worried about the overall texture, go with krylon fusion in black after a good sanding and rubbing down with alcohol. -- DougW |
thats the paint I was thinking about heard lots of good things about it
"DougW" > wrote in message news:uuVDe.26700$mC.15693@okepread07... > Pi-Eyed Piper did pass the time by typing: >> It's peeling but not that much. I have blasted it, not much comes off. > > I'm not aware of any paint strippers that don't melt plastic. Possibly > call > your local auto repair/repaint folks or paint supply store and ask. They > might have something new. > > Careful application of heat and a soft pine scraper, but generally the > best > approach is to wet sand and repaint. If it's real nasty you might need to > sand > down to the base plastic. If your not worried about the overall texture, > go > with krylon fusion in black after a good sanding and rubbing down with > alcohol. > > -- > DougW > |
Pi-Eyed Piper did pass the time by typing:
> thats the paint I was thinking about heard lots of good things about it I've played with it (painted the inner fender wells) so far it's holding up well. But then again it hasn't gone through a winter yet. A few folks at work have done dash bits and outdoor furnature, they seem to think it works well (at least I haven't heard any bad things). -- DougW |
All times are GMT +1. The time now is 05:39 PM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
AutoBanter.com