Pump stand
 

I know that you should stand the pump on something to (hopefully) keep it
out of the silt and the most common thing for this purpose seems to be
bricks. Well, I haven't got any bricks to hand but I have got a couple of
breezeblocks; are these safe to use? Are there any chemicals that could
leech out or any other reason why I shouldn't use them? Or should I just get
a couple of bricks?

Cheers,

Mogweed.
--
No trees were cut down or harmed in the sending of this message. A lot of
electrons were, however, severely inconvenienced. Change words to numbers to
email.

Pump stand
 

"Mogweed" wrote:

Hello Mogweed

M I know that you should stand the pump on something to
M (hopefully) keep it out of the silt and the most common
M thing for this purpose seems to be bricks. Well, I haven't
M got any bricks to hand but I have got a couple
M of breezeblocks; are these safe to use? Are there any
M chemicals that could leech out or any other reason why I
M shouldn't use them? Or should I just get a couple of bricks?

It's fine, as long as it's not some fancy type of block with bonded
insulation. (You probably have concrete block, not breeze block - the
latter's much lighter and releases bubbles for half an hour after you
submerge it)

Anyway, it doesn't matter what you use as long as it keeps the pump
off the floor 2 or more inches and is fairly stable.

--
Simon Avery, Dartmoor, UK Ý http://www.digdilem.org/

Pump stand
 

"Simon Avery" wrote in message
...
"Mogweed" wrote:

Hello Mogweed

M I know that you should stand the pump on something to
M (hopefully) keep it out of the silt and the most common
M thing for this purpose seems to be bricks. Well, I haven't
M got any bricks to hand but I have got a couple
M of breezeblocks; are these safe to use? Are there any
M chemicals that could leech out or any other reason why I
M shouldn't use them? Or should I just get a couple of bricks?

It's fine, as long as it's not some fancy type of block with bonded
insulation. (You probably have concrete block, not breeze block - the
latter's much lighter and releases bubbles for half an hour after you
submerge it)

Anyway, it doesn't matter what you use as long as it keeps the pump
off the floor 2 or more inches and is fairly stable.

--
Simon Avery, Dartmoor, UK Ý http://www.digdilem.org/

Thanks very much for that Simon. I can now rest easy and chuck my blocks in
tomorrow.

Cheers,

Mogweed
--
No trees were cut down or harmed in the sending of this message. A lot of
electrons were, however, severely inconvenienced.

Pump stand
 

"Mogweed" wrote in message
...
I know that you should stand the pump on something to (hopefully) keep it
out of the silt and the most common thing for this purpose seems to be
bricks. Well, I haven't got any bricks to hand but I have got a couple of
breezeblocks; are these safe to use? Are there any chemicals that could
leech out or any other reason why I shouldn't use them? Or should I just
get
a couple of bricks?

Cheers,

Mogweed.

Some people will say that it is ok to use them. I wouldn`t. I would have
more faith in a couple of bricks. Proberly 50 pence from a builders
merchants or a demolision site. Any body got a skip near you?
Protect the bit of the brick that touches the pond liner. Bricks can have
sharp edges. I had some bits of pond liner left over and I wrapped the
bricks in it!

--
IAN. P. GARDNER
ISLE OF WIGHT
www.gardner44.freeserve.co.uk