http://groups.msn.com/chaniarts/shoe...to&PhotoID=194

2x6 construction. aluminium box rails for the verticals. oak skins.
purchased raised panel doors from home depot.

don't route out the top rails. instead, make the side skins be taller and
overlap the plastic frame. looks the same, but lots stronger.

regards,
charlie
cave creek, az

"Frank" wrote in message
...
WOW, that makes my stand look like a piece of $#!%. Thanks for the pics,
now I know how to make mine look good.

Frank


"Darrin O'Bryan" wrote in message
news
I built mine using the stand in this link as a model.

http://www.sal****erfish.com/vb/show...threadid=85215

I covered my stand in oak plywood with some decorative trim. I put the
plywood about an 1 1/2" above the top 2x4 piece to provide a lip and my
tank
rests solidly on the 2x4. I would think that routering the 2x4 may
weaken
the top to much.

HTH
Darrin



"Tre' Landrum" wrote in message
news:xlcVd.46$Qz.15@okepread05...
Anyone have any experience in building tank stands? Things like where
exactly do you put the support... router out the top of the 2x4 for the
tank to recess into? put a border around the edge? I am quite good at
wood
work...but I just want to make sure it doesn't come crashing down.
Thanks!

Tre'