I would contact hagen...you might find a contact email adress on
www.hagen.com
that would be the best option.

I heard that the O ring has to be wet when you first put it on...its all in
the manual.

Make sure that you have put everything together correctly..sometimes if the
baskets arent sitting correctly, it can make everything else not fit.
HTH
"Lobsang Mack rogers com" hmack atdot wrote in message
...
I have a Fuval 404 that is just over a year old. I had to replace the
impeller and impeller cover. The problem is that I am getting a small
amount of leaking around the handles so I replaced the motor housing
O-ring. Because of this it is not working.

Any suggestions.

--
----------
www.fotosbyharvey.ca

Logic is a tweeting bird in a green meadow. - Mr. Spock