I go against the conventional wisdom with drain fittings on skimmers. I
added one to my CS12-2 ER skimmer and run the skimmer wet, producing
approximately a gallon of skimmate per day. Running it this way makes the
neck of the skimmer self cleaning (at least on the inside of the neck where
it matters), and I clean the skimmer cup every couple of months just for
appearance as the operational surfaces of the skimmer are self cleaned.
Running a skimmer this way is low maintenance, but maximizes skimming
efficiency and gets continual small water changes when I dump in a gallon of
SW daily to replace the skimmate,
Mike
"Dragon Slayer" wrote in message
...
I'd recommend the upgrade to the pro without a doubt.

as for the drilled fitting, I tend to think adding fittings makes the
reefer
lazy when it comes to cleaning the cup and therefore they are not a wise
decision to add. a dirty riser tube drastically reduces a skimmers
performance.

kc


wrote in message
...
Ok here we go 30gal 12x36x16 . I've been out of the hobby a couple years
and was always
skimmerless but have decided to use one this time.
Heres the deal I havn't made up my mind on a sump yet so I need a hang
on.
my choices seem to be
Prizm (really hot when I crashed)
CPR Bac Pac ( I kinda like this one because of the preskimmer.)
AquaC ( have read good things but no preskimmer and uses a rio pump
unless
you upgrade)

I plan on ordering something in the next few days so
All thoughts and suggestions are appreciated
Thanks





**********End Of Post*************

I want to say thanks for the input so far, I have decited on the Remora.
Now I have to decide on if spending the extra $70 for the pro is worth
it
for future use.
Hopefully everything will be going into my 75 or 100 gal with one being
a
sump,
next fall after we sell this place. so the Ques. is buy another 96w of
light or go
with the pro.( I have an ah supply 96w50/50 sitting on it now.)
2nd Ques is has anyone had the cup drilled? Is it worth it? From what
I've
been
reading the cup should be wiped out frequently for performance reasons.

Thanks again guys