Thread
:
My Heater Keeps Slipping
View Single Post
#
6
October 12th 05, 08:52 PM
George Pontis
external usenet poster
Posts: n/a
In article om,
says...
Hi everyone,
I have a problem with my heater. I have one that hangs off the edge of
the tank, but it keeps slipping down too low and I feel like it's gonna
eventually short out and fry my fish. So, I'm looking for suggestions
on fully submersible heaters, as I like the idea of them better anyway.
Thanks,
Chris
Unlikely that your fish would be harmed electrically, it would be more of a risk
to you when you stick your hand in the water. However, these hang on back heaters
tend to be cheaply built and more failure prone than the submersibles, even under
the best of conditions. If you are interested to buy a new heater, my suggestion
is the Hagen Tronic.
For any heater, they will work better if the heating element does not too directly
warm the temperature sensor. You can minimize that problem by locating the heater
in an area of water circulation. For submersibles, you also have the option of
mounting the heater at a 45 degree angle or even horizontally in the tank.
For more information:
http://www.netmax.tk/
George Pontis