"TekCat" wrote in message ...
I am looking at lots of sump designs,... unfortunately they are all too big
to fit it in my stand. I hate Wal-Mart ))) the stand is from them... it
divided into 2 sections, they are completely separated from each other, and
there is only a 10G tank would make in the section. So, I am stuck there
with 10G sump. Or maybe two tanks with some creative plumbing going around
the stand's poor design. One tank would have skimmer and return sections,
and another would be a fuge. I since the skimmer (AquaC Remora) is a hang
on, I'd estimate my skimmer section (with intake would) take 3 gallons, and
use remaining 7 for the return section.

You know, the buty part about Walmart is that if you are not happy about the
product you buy you can pack it and carry back to the store for a refund ;-)

Since it is the way I am most likely going to go (glass tank), my first
choice is acrylic for baffles, compartments, etc... What type of glue
I need to use to glue acrylic to glass?

Bad idea. Cut the glass and glue it with silicone.

P.S. Pszemol, The RO/DI saga came to the happy end. My membrane was the
problem, recently I got replacement. It works like a charm. I am very
happy though ) I estimated that with booster pump running I am getting
approximately 110GPD. AWESOME!!!! )) Thanks for your help.

Glad to hear this.