ALSO check of this site.. its a wealth of knowledge
http://www.melevsreef.com/ the Author of this site is often on this new
group and is a genius when it comes to reefs. Surf it and you will learn.

"Peter Pan" wrote in message
...
Start by setting up your tank by using live sand as well as regular sand
you get from a live fish store (LFS). You want enough sand to make a
minimum of 4" bed. Make sure you rinse the sand prior to putting it in the
tank or else you will get cloudy water. Once the sand is rinsed and you
put it in the tank, arrange the Live Rock (LR) the way you want it. Using
a Reverse Osmosis _Di-Ionization (RODI) Mix you water and salt in a
separate container to the specific gravity. Once its mixed, begin to add
the water to your tank. your best bet is to use a new Rubbermaid trashcan
for mixing your water/salt and pump the water into your tank once its
done.( With a RODI this process will take all day).
Once your tank is topped off, use your power heads to circulate the water,
I suggest one on each side of the tank for good water movement.

Now just because your tank has water in it does not mean you can add fish.
In a few days, test your water, you will see your ammonia is off the
charts( this is normal but bad for fish). In a few weeks (3 or so) do
another test of the water. you should see some improvement in your
ammonia. After 4 weeks or so, do a partial water change, this is where you
remove %10 - 20 of your water and replace it with freshly mixed
salt/RODIwater.. This takes time.. your tank needs to cycle .(This should
take a 60 days or longer then it's time to add fish. Once you reach 0.0
ammonia, its time to add fish.

LIGHTING. Make sure you put your lights on a timer. I have mine turn on
around 2pm and off around midnight. Lighting is also important in helping
your tank mature.

This whole thing is a process.. it takes time and patience. when you get
stuck, come to this message board and post your problem.. you will find
your answer.
Good Luck
"Harry Ohanian" wrote in message
...
Hello All

I have an 95 gallon Oceanic tank with a trickle filter.
I would like to set it up fish only.
What to do? How should I go with the filter system?
How much live rock?
Is lighting needed for live rock?
I've read about the bio balls putting nitrates in the tank so I'm
confused about the trickle filter.
Any insight is well appriciated.
Thanks

Harry Ohanian