"Jerry Baker" wrote in message news:JMCRg.1466$Wi1.382@trnddc06...
Pszemol wrote:
Who is the manufacturer ? Is this Allglass tank ?

Lee-Mar. They are a local California company.

Shame...

Or design a new comb from a piece of black plastic and
cover the old one slightly higher.

The plastic already goes to the top of the tank. I can't go over it,
only plug teeth up.

How long are the vertical cuts between teeth ?
Maybe you will be able to cover bottom part of comb on
its whole lenght with a stripe of black plastic - this way
it will look better than pluging each tooth separatelly.
Each cut will be shortened this way and water level will
be lifted up.