Yes, it was a bad design decision...they needed a knob there to turn, not a
screw slot! Further, always getting the open position aligned to get the
cover off can be deceptive, and a pain!


"Eric Schreiber" wrote in message
...
(Kate) wrote:

I have an Eclipse and need to change the lightbulb or stabilise it so
it stays on. there are two little plastic screws but they don't seem
to come out. what am I missing?

Assuming yours is similar to the Eclipse 2 hood, you're right - the
screws don't come out. Just turn them 90 degrees counter clockwise,
and the clear light cover will come right off.

--
www.ericschreiber.com