View Single Post
  #1  
Old October 27th 03, 12:11 AM
No-Name
external usenet poster
 
Posts: n/a
Default Filter at end (side) of tank?

I have two (2) Emperor 400s now - would one Fluval 404 provide equal
filtration and biological action - I'm pretty happy with the Emperors right
now - the seem to do a great job!

"Amateur" wrote in message
. com...

"No-Name" wrote in message
...
I've seen a few pictures of tanks used as a room divider - I like the

look,
but can't figure out how I'd handle the issue of the filters, if I'm

using
back-filters like the Emperor 400 - to eliminate filters on either the

front
or the back side of the tank, I guess I'd have to go to a sump-type

system -
or is there another alternative? If I go to a sump, would I have to

drill
the tank, or is there a provision for the suction and return tubes to go
over the top of the tank at the end of the tank? Thanks for any
suggestions.



The most clean way to do it would be to drill the tanks, that's if they're

not
tempered and can be drilled. You can buy predrilled tanks. If you don't

already
have the tank, the all-glass 180 gallon tank would look nice. The cutout

on one
wall would be a little narrower than on the other wall as the built in

overflow
covers a few inches on each corner in what's normally the back of the

tank. In
my overflows on my rack system, the overflow is simply a piece of pvc

tubing
with vents cut in the top of the tube. The top of the pvc is about a half

inch
down from the top of the tank with the lowest cut about an inch beneath

that.
You can have another piece of pvc coming up into the tank from the bottom

for
the return as well.
There are overflow systems that have a small box you could hang off the

side of
the tank that work on siphon. Or you could have a cabinet above the tank

with
the sump over the tank and pump up to it. This would eliminate the need to
drill. Drill bits are expensive and difficult to use and I couldn't find

any
glass places that would take the responsibility of drilling a tank for me.
The other option is a canister filter like the fluval 404. You could set

one up
on each end. Depending on how the tank was stocked, that would probably

keep up
with most of your filtration needs.
Amateur
www.amateurcichlids.com