well, now I know for sure what the problem is. The ****ing asshole that I
bought my house from decided to run an outlet with no ground. Of course I
only became aware of it when I was standing in water with my hands in the
sump. This receptacle is in my garage, a place where you use tools,
wouldn't it make sense to have the outlets grounded ?

While I would love to get the guy, a better solution would be to have an
electrician come and wire the receptacle correctly.


"plaguebeast" wrote in message
...
This one is submerged but another Mag 7 I have on a different tank was
suspect in warming the water in the sump. (it was only a suspect as the
real
culprit was a Rio that had it's intakes partially blocked)

I was hoping that one of the other Mags might be able to suck air and
water,
allowing the pump to sit at the same level as the water level in the sump,
with a pipe leading from under the water, up and over the side and then
back
down to the pump which would be sitting on the same surface as the sump.
I
build the pipe but as soon as I turned on the Mag I remember that it was a
centrifigal pump and was not going to be able to suck the air through the
pipe. Anyway, to make a long story short, the pump went back into the
sump
and the heating issue was resolved another way. I just wanted to know if
there was a way to locate the Mag outside of the sump, somehow drawing the
water up and then down to it.

As far as the Mag with the possible short/leak, I am no longer interested
in
testing the problem. I bought another Mag7 and replaced the bad one. If
my
conscience allows me, I will just return the faulty one claiming it was
the
one I just bought today and that it was shocking me. I have spent a few
thousand dollars there, I don't feel bad and according to the guy in the
store, they will just send it back anyway, so no skin off their back, I
just
won't have to deal with a long phone call with Marine Depot.


"Marc Levenson" wrote in message
...
Yes, I'm talking about pushing in the plugs a little more firmly. I
was
getting shocked by my tank for a week, and it turned out to be the 6-way
outlet
wasn't plugged in all the way. Talk about a simple fix!!!

However, if your Mag drive is defective, send it back! I had to do that
myself.

You mean have the pump not submerged, and have it draw water up into it?
You'd
have to hook up some type of p-trap and a vent to keep some water in the
pump at
all times, and that is something I've never tried to do.

Marc


plaguebeast wrote:

Marc,

I am not sure if you are encouraging me to press the plug in
harder
to
allow the pins to make better contact for more voltage or better
contact
for
the ground pin and I am almost too scared to ask. Instead I am going
to
go
get a new Mag 7 and send this one back to Marine Depot on Monday.

Any idea of the other Mag drives, like a 9 or higher, can suck water
from a
lower point ? I guess it would need to have a bleed valve to let the
air
out.

"Marc Levenson" wrote in message
...
LoL. I would suggest that next time you have that event, try
pressing
all
plugs
into their respective outlets firmly and see if that doesn't make
the
"shock
test" easier to perform.

Marc


plaguebeast wrote:

"plaguebeast" wrote in message
...
Can a PS generate current into the sump that it is sitting in ?
Last
night
I was able to put my hand into my sump, now, 8 hours of running
time
later,
I get a mild, but nonetheless unpleasant shock that does not
seem
to
discharge or kick my GFCI.

Any ideas ? I don't think troubleshooting this is going to be
easy. I
guess
I could use a multitester with on probe in the sump, but where
would I
put
the ground ? If the voltage was being caused by a regular
electrical
short
then the GFCI should have tripped but it did not. So, where do
I
put
the
ground from the voltmeter ?




ok, never mind, seems like the problem is in the Mag 7. I swapped
it
out
for another Mag 7 and it didn't shock me. What a crappy way of
testing
for
the problem...ok, stick my finger in the water a little bit and
see
if I
feel anything, nothing ? ok, put my whole hand in, no shock, ok,
found
the
problem. It was only a little shock but enough to let me know
that
there is
a problem.

--
Personal Page:
http://www.sparklingfloorservice.com/oanda/index.html
Business Page: http://www.sparklingfloorservice.com
Marine Hobbyist: http://www.melevsreef.com



--
Personal Page: http://www.sparklingfloorservice.com/oanda/index.html
Business Page: http://www.sparklingfloorservice.com
Marine Hobbyist: http://www.melevsreef.com