"donJ" wrote in message
om...
Thanks for the reply. The surface is pretty flat, but not perfect.
When I place the empty tank on the stand (home made), there's a little
bit more than a 1/16 of inch difference between the tank and the stand
(on one side). Is that good enough?



as long as it's not a large gap it will be ok. As long as 99% of the frame
is supported it should be fine. My 135 has about a 6" section that I can
slide a piece of paper between the full tank and stand, and it has been fine
for 16 years ;o)

--

Margolis
http://web.archive.org/web/200302152...qs/AGQ2FAQ.htm
http://www.unrealtower.org/faq