Thread
:
Flushing cooling system on GMC Savanna.........
View Single Post
#
5
April 1st 06, 03:50 PM posted to rec.autos.tech
Peter Griffin
external usenet poster
Posts: n/a
Flushing cooling system on GMC Savanna.........
On Sat, 01 Apr 2006 14:36:22 GMT,
wrote:
> "Peter Griffin" > wrote in message
> .. .
>> On Sat, 01 Apr 2006 13:26:21 GMT,
wrote:
>>
>>> "Peter Griffin" > wrote in message
>>> ...
>>>> Ok...same 99 Gmc Savanna 5.7l as usual...now I just finished changing
> the
>>>> intake manifold gaskets, and I figure I'll scab up enough tonight to
>>>> undertake the coolant flushing tomorrow...Question is a friend
> suggested
>>>> vinegar as a flushing agent...Any pro's or cons will be appreciated...I
>>>> just planned on filling with water getting to temp...draining a few
>>>> times...thanks in advance ...
>>>
>>> I wouldn't waste my time with vinegar. It isn't acidic enough to really
>>> do any good with respect to any iron oxide that may be in the system...
>>> at least over the short term. And if you dont get it completely washed
>>> out, it could offset some of the corrosion protection you might expect
>>> from your coolant corrosion inhibitor package.
>>>
>>> The idea isn't totally off base, just too weak to be effective.
>>
>> not do concerned with the corrosion, more about the dex cool coolant
> mixing
>> with the residule in block
>
> The reason you have products like DexCool and other prepared coolant
> formulations is to offset corrosion in the block and radiator.....ordinary
> ethylene glycol or propylene glycol work perfectly well as antifreezes
> and coolants without any sort of proprietary chemical additives.
>
> I am not sure that that fact has been stated often or is clearly understood.
>
> Yes, you want to get the block and radiator as clean as possible, and a
> thorough water flush is about as good as you can do it. The vinegar is
> not really going to help you.
>
> And if you drop the pH of the OAT DexCool, you will convert the organic
> salts (which are extremely water soluble) into organic acids. These acids
> are not very soluble, and will scum out in the block and radiator.
>
> When I do this job, I normally remove the thermostat, and flush repeatedly
> through the block and through the radiator until everything runs clean.
> (and replace the thermostat with a new one when I am finished.)
>
> Your vehicle is now approaching 6-7 years old. If you have not replaced
> hoses before, this could be a good time to do it. It is hard to predict
> when
> they are likely to fail, but 5 years, 100,000 miles, is certainly getting
> into the
> zone where a replacement wouldnt hurt.
While doing the intake gasket set, I also did the serpentine belt, and
inspected/cleanes everything...The hoses seemed fine, but The thermostat is
a good idea, somehow I overlooked it, probably too concerned with labeling
all plugs/bolts, and cleaning up all the blood from scrapes....should of
just yanked the engine/trans instead of doing the intake in the van
also noticed upper rad hose is seaping now....think it is the disposable
clamps they use now..........
Peter Griffin
View message headers
Ads