I always just use a socket wrench for bleeder screws. The 6 sided
socket fits the best. Once they are loose, I then use a box end wrench
to bleed them.
Now that they are damaged, I would use a vise grip to just tighten the
loose one.
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Canadian Off Road Trips Photos: Non members can still view!
Jan/06
http://www.imagestation.com/album/pi...?id=2115147590
(More Off Road album links at bottom of the view page)
bryanska wrote:
>
> Hi,
>
> I bled the brakes in my 2002 Alero yesterday, for what I plan is the
> only time. I'd like to know the bleeding process I'll have to follow,
> now that I have to replace one bleeder screw.
>
> Two of the bleeder screws were rounded in the process. I used a flare
> nut wrench specifically designed for softer fasteners.
>
> One of these rounded screws was apparently not tight enough. I
> discovered it was leaking. I capped off the bleeder screw with a small
> plastic cap and hose clamp. Today I plan on buying new bleeder screws
> and installing them.
>
> I understand I'll have to re-bleed the wheel where I'm replacing the
> screw.
>
> 1) Will I have to re-bleed all the wheels?
>
> 2) Will I have to bleed the master cylinder?
>
> I'm not looking forward to this, but I have a Mity Vac and hopefully
> that wil make things better.