![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I was reading some information on an OASE pressurized filter this morning
and wondered what folks thought about pressurized filters as compared to non-pressurized. Anyone had any bad experiences with one? Good experiences? Preference for one type over another? I currently have an 1,100 gallon pond using a bio falls filter. I'm moving to a new home and plan on building a 2,500 or so gallon pond. Just fishing for information. Thanks. John |
#2
|
|||
|
|||
![]()
On Tue, 22 Jun 2004 01:17:59 GMT, "JB" wrote:
I was reading some information on an OASE pressurized filter this morning and wondered what folks thought about pressurized filters as compared to non-pressurized. Anyone had any bad experiences with one? Good experiences? Preference for one type over another? I currently have an 1,100 gallon pond using a bio falls filter. I'm moving to a new home and plan on building a 2,500 or so gallon pond. Just fishing for information. Thanks. John I use a Aqua Ultraviolet Ultima II 5.0 pressurized filter. I chose a pressurized filter because I wanted to locate it below the level of the pond. This wouldn't be practical with a non-pressurized filter. Steve J. Noll | Ventura California | Glass Block Pond http://www.kissingfrogs.tv |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
ATI and Lustar Hydro-Sponge filters, are they the same thing? | Harry Muscle | General | 2 | April 1st 04 04:00 PM |
D-I-Y replacement filters for penguin bio-wheels | E.Otter | Goldfish | 5 | October 8th 03 05:17 AM |
Pressurized CO2 tank problem | Joey | Plants | 12 | August 16th 03 06:17 PM |