![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I am trying to figure out if need to add more outlets around my tank. In
the future I want to upgrade to MH lighting and was not sure if my current set up would be safe adding Mh also. This is what I have now and maybe you could answer my question. I am currently using 2 outlets, both are on the same circuit. Icecap 660 with 440 watts of VHO lighting, mag 9.5 & 7 for tank circulation & skimmer, 200 watt heater, 2 maxi jet power heads and fan in canopy, & 2 other outlets for my calcium reactor. In the future I will probably upgrade to 2 175 watt MH with VHO. My question is would I need to add another outlet or 2 from the breaker box to run all of this safely or go to a higher amp breaker. Thanks Travis |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY Electrical question | Lawrence | General | 9 | March 23rd 04 08:43 PM |
Newbie question | Matthew Heath | General | 3 | December 4th 03 02:24 PM |
question about trickle filters... | Jon Pike | Tech | 4 | October 12th 03 10:00 PM |
Reverse Osmosis Question... | gizmo | Tech | 1 | September 4th 03 01:27 AM |
I need a very simple answer to a lighting and filter question. | Ben | General | 8 | July 26th 03 07:12 AM |