|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 17th 05, 05:27 AM
|
|||
|
|||
New News on "Lots of Ammonia"
I forgot to mention that from the start my pH reading was ALWAYS 7.4.
On 02/16/05 when I started to get my ammonia down and nitrite/nitrate up the pH reading was 6.0. I had to use Sodium Bicarbonate to increase pH level. I will take another reading tomorrow and probably use "BOOLSEYE 7.0) 
|
|
#2
February 17th 05, 05:47 AM
|
|||
|
|||
|
On Thu, 17 Feb 2005 00:27:14 -0500, "Richard Holub"
wrote: I forgot to mention that from the start my pH reading was ALWAYS 7.4. On 02/16/05 when I started to get my ammonia down and nitrite/nitrate up the pH reading was 6.0. I had to use Sodium Bicarbonate to increase pH level. I will take another reading tomorrow and probably use "BOOLSEYE 7.0) Looking forward to updates. ~ jan ~Power to the Porg, Flow On!~
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New News on "Lots of Ammonia" | Richard Holub | General | 1 | February 18th 05 06:48 PM |
| ammonia problems | *muffin* | Goldfish | 8 | June 12th 04 09:08 PM |
| nitrite spike, no ammonia! | Jason in Oakland | General | 4 | February 27th 04 04:37 PM |
| High Ammonia Readings -test kits/ammonia removers | Spark_001 | General | 0 | September 27th 03 05:46 PM |
| Water parameter and test strip questions... | Teeb | Reefs | 11 | July 31st 03 01:37 PM |
Linear Mode
