![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I use a stock tank heater to maintain a hole in the ice on my pond. My
question is how large a hole is required? I have a 1200 gallon pond. My heater is 1000 watts and keeps about a four inch hole in the ice. don cunningham |
#2
|
|||
|
|||
![]()
Any sized hole will work - mine is currently ~ 5" with an airstone - the
point of the hole is to allow air exchange so toxic gases don't build up, trapped beneath the ice Gale :~) "Don Cunningham" wrote in message ... I use a stock tank heater to maintain a hole in the ice on my pond. My question is how large a hole is required? I have a 1200 gallon pond. My heater is 1000 watts and keeps about a four inch hole in the ice. don cunningham |
#3
|
|||
|
|||
![]()
Hmmmm...
I don't think we've ever addressed the size of the hole to be kept open in the ice that I remember. If you are concerned you can add an air pump and bubbler and that will increase the size of the hole as that worked for me during an especially bad winter (for us). kathy |
#4
|
|||
|
|||
![]()
kathy wrote:
Hmmmm... I don't think we've ever addressed the size of the hole to be kept open in the ice that I remember. If you are concerned you can add an air pump and bubbler and that will increase the size of the hole as that worked for me during an especially bad winter (for us). kathy My feeling is that if you've got a good vigorous bubble-stream going, the size of the hole isn't critical: the gas exchange will be driven more by the bubbling than the exposed surface area. It probably even gives you some lee-way if the hole freezes over completely: if air is going in, it *must* be coming out, and presumably exchanging oxygen for waste gasses along the way. Not that you shouldn't re-open it, but you probably don't need to panic and rush out in your PJs at 3AM in mid-January, either ;-). -- Kizhe |
#5
|
|||
|
|||
![]()
I have a related question about the need for holes in the ice.
If your method of keeping a hole in the ice fails, how quickly does a hole need to be re-established? I realize that the amount of vegitation in the pond might make a difference, but if the water is near freezing, doesn't the vegitation decay slow down significantly? Has anyone lost fish after just a day or two? How about a week or so? I'm just curious about this. My pond (north of Denver) is ice free at the moment, which is a little bit usual for this time of year. The bubler has been doing fine any. Jerry "Don Cunningham" wrote in message ... I use a stock tank heater to maintain a hole in the ice on my pond. My question is how large a hole is required? I have a 1200 gallon pond. My heater is 1000 watts and keeps about a four inch hole in the ice. don cunningham |
#6
|
|||
|
|||
![]() If your method of keeping a hole in the ice fails, how quickly does a hole need to be re-established? Has anyone lost fish after just a day or two? How about a week or so? I had a bad experience a few yrs back when we got a heavy snowstorm, burying my airpump container and whole back yard in 3' of snow. I could still hear my pump running , so thought it will be OK for a few days until some of the snow melts back - a week later, I thought I better clear a spot to check my hole in the pond - the ice was gone on the pond and all that was left was a snow crust ~2' deep (I had 4" of ice on the pond when the storm hit and I had been walking on it) - the snow insulation warmed the water and melted the ice , but the worst part was , even though I could still hear my airpump running, it broke and was pumping nothing - When I put a shovel in the snow to dig down to the hole, the snow crust caved in and the water was almost black, then my 3 large Koi and the 4 largest GF floated to the surface and they hadn't been dead long Now I put my airpump container 3' off the ground so I can check it often and keep it clear of snow. Whenever my airhole ices over, I open it up as I've found the ice dome that forms in really cold weather keeps getting thicker if left intact Just my experiences Gale :~) |
#7
|
|||
|
|||
![]()
On Sat, 5 Feb 2005 16:51:25 -0500, "Gale Pearce"
wrote: If your method of keeping a hole in the ice fails, how quickly does a hole need to be re-established? Has anyone lost fish after just a day or two? How about a week or so? I had a bad experience a few yrs back when we got a heavy snowstorm, burying my airpump container and whole back yard in 3' of snow. I could still hear my pump running , so thought it will be OK for a few days until some of the snow melts back - a week later, I thought I better clear a spot to check my hole in the pond - the ice was gone on the pond and all that was left was a snow crust ~2' deep (I had 4" of ice on the pond when the storm hit and I had been walking on it) - the snow insulation warmed the water and melted the ice , but the worst part was , even though I could still hear my airpump running, it broke and was pumping nothing - When I put a shovel in the snow to dig down to the hole, the snow crust caved in and the water was almost black, then my 3 large Koi and the 4 largest GF floated to the surface and they hadn't been dead long Now I put my airpump container 3' off the ground so I can check it often and keep it clear of snow. Whenever my airhole ices over, I open it up as I've found the ice dome that forms in really cold weather keeps getting thicker if left intact Just my experiences Gale :~) One of the issues involving the use of aquarium type pumps is that they are diaphragm pumps. When the diaphragm gets cold it stiffens reducing the ability to move air or create any pressure. If you put your airstone deep at all, as I do to get it below the ice pack, the pressure created during cold weather may not be enough to move any air. The solution is to keep your pump warm with some kind of heater or use a different type of pump. John |
#8
|
|||
|
|||
![]()
Jerry wrote
Has anyone lost fish after just a day or two? I did. Out of the blue our temperature dropped from the middling 30s and no ice on the pond to 19 below over night. Our power went off for much of the day, then it snowed, and snowed and snowed and hordes of teenagers got stuck at our house and needed feeding and shelter and we had wall to wall to wall band practice... I think I got out to the pond by the end of the second day to melt a hole in the ice and then put in a heater and a bubbler. Lost a lot of fish. kathy |
#9
|
|||
|
|||
![]()
Jerry wrote:
Has anyone lost fish after just a day or two? This is a question for a mathematician, something to the effect of: Gallons : inches of mulm : fish mass : time left unattended. Then there is the emotional factor: Price of Fish : Emotional Attachment : Death ~ jan ~Power to the Porg, Flow On!~ |
#10
|
|||
|
|||
![]() One of the issues involving the use of aquarium type pumps is that they are diaphragm pumps. When the diaphragm gets cold it stiffens reducing the ability to move air or create any pressure. If you put your airstone deep at all, as I do to get it below the ice pack, the pressure created during cold weather may not be enough to move any air. The solution is to keep your pump warm with some kind of heater or use a different type of pump. I agree about a different type of pump (piston, outdoor type), but they are expensive and have found the Optima acquarium pump works well at 2" - 3" deep in my pond - I replace the diaphragm assembly every 3 yrs and have had no trouble since (I was using a smaller, cheaper one that broke) I just keep making sure the ice dome doesn't get thick (another story!) and make sure the bubbler is bubbling Gale :~) |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Is this Hole In The Head? | Flash Wilson | General | 2 | January 8th 05 01:02 PM |
Drilling hole in glass aquarium- | Mike | Reefs | 6 | June 16th 04 09:09 AM |
Hole in my tank | Nick Rogers | Reefs | 14 | June 1st 04 05:52 PM |
Help! Air bubbler is running but there is no hole in pond... | D Kat | General | 5 | January 19th 04 02:40 PM |
KENT - float switch - where to drill the hole | Pszemol | Reefs | 7 | August 1st 03 07:17 PM |