|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 20th 05, 12:47 AM
|
|||
|
|||
M3 CO2 gauge
In a fit of brilliance, I blew out the working pressure gauge on my M3
CO2 regulator. Are these available? Has M3 gone out of business (I can't find them on the web anymore)? Any suggestions? Thanks! Bob Ontario, California 
|
|
#2
May 20th 05, 02:41 PM
|
|||
|
|||
|
Go to your friendly neighborhood welding shop. They may not have a M3
but they should have a gauge you can use.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| This one seems to cause some very negative comments. | spiral_72 | Plants | 46 | February 7th 05 03:45 PM |
| How to regenerate "KENT Mixed Bed Resin Cartridge"? | Pszemol | Reefs | 22 | October 30th 03 05:50 PM |
| Problem with steady bubble rate for calcium reactor | AquaD3843 | Reefs | 1 | September 7th 03 04:35 AM |
Linear Mode
