|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 10th 04, 02:42 AM
|
|||
|
|||
input on calcium reactor
I have some pics of the pluming ruffed out for my reactor I would like your
input on. The main tube well be 16"tall the second tube well be 12" tall so I can mount the pump on it. The base well be 7" wide by 14" long. http://web.tampabay.rr.com/myreef/calciumreactor.htm Thank you Steven m -- http://web.tampabay.rr.com/myreef 
|
|
#2
June 10th 04, 04:26 AM
|
|||
|
|||
|
input on calcium reactor
I have some pics of the pluming ruffed out for my reactor I would like your
input on. The main tube well be 16"tall the second tube well be 12" tall so I can mount the pump on it. The base well be 7" wide by 14" long. http://web.tampabay.rr.com/myreef/calciumreactor.htm you might consider putting the 2 T's where the water goes in on the same side. alternatively put only 1 T at the pump end and use a small T for the water/co2 in, otherwise seems good to me. -- Richard Reynolds
|
|
#3
June 10th 04, 08:56 AM
|
|||
|
|||
|
input on calcium reactor
My only suggestion would be to switch your water in a co2 in. With your
co2 being injected that far above the pump if the flow is slowed down as the media compacts, you could end up with bubbles not being pulled down into the pump. kim steve m wrote: I have some pics of the pluming ruffed out for my reactor I would like your input on. The main tube well be 16"tall the second tube well be 12" tall so I can mount the pump on it. The base well be 7" wide by 14" long. http://web.tampabay.rr.com/myreef/calciumreactor.htm Thank you Steven m
|
|
#4
June 11th 04, 03:25 AM
|
|||
|
|||
|
input on calcium reactor
- "kim gross" wrote in message ... My only suggestion would be to switch your water in a co2 in. With your co2 being injected that far above the pump if the flow is slowed down as the media compacts, you could end up with bubbles not being pulled down into the pump. kim thanks you both steven m - http://web.tampabay.rr.com/myreef
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Calcium reactor considerations | Christ's Soldiers | Reefs | 4 | February 17th 04 07:20 AM |
| alkalinity | Dinky | Reefs | 86 | February 13th 04 10:36 PM |
| Bubble Rate of Calcium Reactor | MarkW | Reefs | 0 | January 7th 04 06:36 PM |
| Azoo Twin Calcium Reactor | B | Reefs | 6 | December 28th 03 09:59 PM |
| Calcium reactor maxed out? | Timothy Tom | Reefs | 2 | November 22nd 03 03:20 AM |
Linear Mode
