|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 22nd 18, 08:32 AM
posted to rec.ponds
|
|||
|
|||
Filter/UV sequence.
I have acquired a pressurised filter (mini dustbin with foam filters inside) and a UV (light in a box) unit. What should be the sequence in which they are linked ? Pump in pond to ...? bin or UV, which comes first ? I was then assuming it will be ok to then link the two units with Flexi hose and then back into the pond. Many Thanks Brian. -- JBL2527 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pmdd- sequence of adding components. | Andrzej Konarski | Plants | 6 | August 24th 05 08:48 AM |
| Sequence Pump | Nan Zitney | General | 1 | August 8th 05 05:36 AM |
| Unfortunate sequence of events :-( | Glenn S. | General | 5 | June 1st 05 09:55 PM |
| Sequence K6 Impeller | Mark Mendell | General | 3 | September 22nd 04 01:00 PM |
| performancepro vs sequence | Grumpy | General | 0 | August 11th 04 10:46 PM |
Linear Mode
