|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 17th 03, 03:41 AM
|
|||
|
|||
Chucks paludarium
Hey Chuck I am in the process of trying to make something similar to your
paludarium. I was wondering how you bonded the styofoam to the aquarium...I assume with silicon...Any tips that you have would be great.. my tank is even smaller its only 33 Gallons. Thanks Ryan 
|
|
#2
September 17th 03, 07:30 AM
|
|||
|
|||
|
Chucks paludarium
On Wed, 17 Sep 2003 02:41:09 GMT, "Ryan Wilson"
wrote: Hey Chuck I am in the process of trying to make something similar to your paludarium. I was wondering how you bonded the styofoam to the aquarium...I assume with silicon...Any tips that you have would be great.. my tank is even smaller its only 33 Gallons. Yes, I used aquarium safe silicone. The construction article covers has just about everything I could remember..... http://www.csd.net/~cgadd/aqua/46g_construct.htm Chuck Gadd http://www.csd.net/~cgadd/aqua
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
