|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 6th 03, 10:16 PM
|
|||
|
|||
Pump power consumption numbers
I purchased a power meter and collected some data on my pump:
From the labels on the pump: Sequence 2400 SEQ10 motor: AO Smith 1.8A 1550 RPM 0.14HP Nothing on the manufacturers website, I think this model has been discontinued. I sort of remember the rated power was 100w. Plumbing (undersized I know): 1" to pond, 3/4 to spraybar. Pump is about 4 inches above water level, 2" inlet pipe. Watts Volt amps Power factor All valves open 107w 139VA 0.77 All valves closed 95w 132VA 0.72 Watts are what you ar paying for. FYI 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Have you ever measured real water pump output flow rate? | Pszemol | Reefs | 26 | January 19th 04 04:33 AM |
| Pump, sump and elbow on the intake | Pszemol | Reefs | 6 | January 3rd 04 01:18 AM |
| pump heat transfer; recommendations ? | Kevin M. Smith | Reefs | 2 | October 11th 03 11:43 PM |
| Pump Confusion | RROLD1 | General | 15 | August 28th 03 05:16 AM |
| I need a good water pump for my pond | Carlos Falcon | General | 1 | August 16th 03 02:19 AM |
Hybrid Mode
