"Tale of Woe"... suggestions?

Is it possible to use a cordless drill with a "spade" bit to drill a 1" hole
to allow you to put an airstone just below the surface of the ice ?
Gale :~)
"BTC/TAK on ACK" wrote in message
...
When a bike-path was put in along my property line a couple of years ago
there were a lot of electric service lines cut or "nicked". It appears
nicked can be worse because it can take a few years before the line
deteriorates. All of a sudden mid-day early in the week my power just went
out! I was "lucky" that I got "temporary" power by the weekend... it will
be
weeks [or more] until another permanent line can be trenched in because of
deep frost. We had succeeded in keeping our pond partially open all
winter,
but it froze over during the time we had no power... pretty thickly in
fact.
In a way that might have been a good thing because since then we had a few
heavy "freezing rains" that flooded much of our yard. We chose the spot
for
our pond to avoid any flooding problem. It looks like it's in the lowest
part of our property, so it appears to be a natural occurrence. But
actually
there's a large hidden area which is quite a bit lower. Flooding has never
gone beyond that area until this weekend, when it was almost a foot over
the
pond, and the top of that even froze over until late yesterday. I was
afraid
the pond itself wasn't frozen quite enough to keep some "adventurous" fish
from escaping into the flood water before the flooding subsided...
especially since the ground is frozen so deeply that it's hardly absorbing
any water. It's apparently absorbing more than we had any reason to
expect,
though, because the water over the pond area is gone [and no dead fish
left
behind, thank God]. The pond itself is still frozen over though. I'm
afraid
to "mechanically" break through the ice in the pond, with an axe for
example, having heard that is dangerous for the fish. On the other hand
I'm
afraid to leave it frozen over much longer because of gaseous build-up
under
the ice. I had effectively been keeping it clear with air bubbles, and
circulating water until last week, but that's not an option now. Any
suggestions?

After you drill the opening, it can be reopened daily with
either the drill or with a teakettle filled with hot water.
The opening doesn't have to be open all the time, but it
should be reopened daily.
Bonnie
NJ

Gale Pearce wrote:
Is it possible to use a cordless drill with a "spade" bit to drill a 1" hole
to allow you to put an airstone just below the surface of the ice ?
Gale :~)
"BTC/TAK on ACK" wrote in message
...

When a bike-path was put in along my property line a couple of years ago
there were a lot of electric service lines cut or "nicked". It appears
nicked can be worse because it can take a few years before the line
deteriorates. All of a sudden mid-day early in the week my power just went
out! I was "lucky" that I got "temporary" power by the weekend... it will

be

weeks [or more] until another permanent line can be trenched in because of
deep frost. We had succeeded in keeping our pond partially open all

winter,

but it froze over during the time we had no power... pretty thickly in

fact.

In a way that might have been a good thing because since then we had a few
heavy "freezing rains" that flooded much of our yard. We chose the spot

for

our pond to avoid any flooding problem. It looks like it's in the lowest
part of our property, so it appears to be a natural occurrence. But

actually

there's a large hidden area which is quite a bit lower. Flooding has never
gone beyond that area until this weekend, when it was almost a foot over

the

pond, and the top of that even froze over until late yesterday. I was

afraid

the pond itself wasn't frozen quite enough to keep some "adventurous" fish
from escaping into the flood water before the flooding subsided...
especially since the ground is frozen so deeply that it's hardly absorbing
any water. It's apparently absorbing more than we had any reason to

expect,

though, because the water over the pond area is gone [and no dead fish

left

behind, thank God]. The pond itself is still frozen over though. I'm

afraid

to "mechanically" break through the ice in the pond, with an axe for
example, having heard that is dangerous for the fish. On the other hand

I'm

afraid to leave it frozen over much longer because of gaseous build-up

under

the ice. I had effectively been keeping it clear with air bubbles, and
circulating water until last week, but that's not an option now. Any
suggestions?

I agree with Gale, a drill, though a stock tank heater element will melt
thru the ice in no time. ~ jan


On 9 Feb 2004 14:24:59 GMT, "BTC/TAK on ACK" wrote:

When a bike-path was put in along my property line a couple of years ago
there were a lot of electric service lines cut or "nicked". It appears
nicked can be worse because it can take a few years before the line
deteriorates. All of a sudden mid-day early in the week my power just went
out! I was "lucky" that I got "temporary" power by the weekend... it will be
weeks [or more] until another permanent line can be trenched in because of
deep frost. We had succeeded in keeping our pond partially open all winter,
but it froze over during the time we had no power... pretty thickly in fact.
In a way that might have been a good thing because since then we had a few
heavy "freezing rains" that flooded much of our yard. We chose the spot for
our pond to avoid any flooding problem. It looks like it's in the lowest
part of our property, so it appears to be a natural occurrence. But actually
there's a large hidden area which is quite a bit lower. Flooding has never
gone beyond that area until this weekend, when it was almost a foot over the
pond, and the top of that even froze over until late yesterday. I was afraid
the pond itself wasn't frozen quite enough to keep some "adventurous" fish
from escaping into the flood water before the flooding subsided...
especially since the ground is frozen so deeply that it's hardly absorbing
any water. It's apparently absorbing more than we had any reason to expect,
though, because the water over the pond area is gone [and no dead fish left
behind, thank God]. The pond itself is still frozen over though. I'm afraid
to "mechanically" break through the ice in the pond, with an axe for
example, having heard that is dangerous for the fish. On the other hand I'm
afraid to leave it frozen over much longer because of gaseous build-up under
the ice. I had effectively been keeping it clear with air bubbles, and
circulating water until last week, but that's not an option now. Any
suggestions?

BTC/TAK on ACK wrote:

When a bike-path was put in along my property line a couple of years ago

Learn how to make paragraphs. That hurts my eyes to read.

I agree with what everyone else said!

I'm just posting here to see if I CAN.
(news server problems....)

Peace!
Dan D. Louisville KY good ole USA
http://ky-dan.com

And just one more try.
Please ignore or forgive me!

Dan D.

Dan D. wrote:
I agree with what everyone else said!

I'm just posting here to see if I CAN.
(news server problems....)

Peace!
Dan D. Louisville KY good ole USA
http://ky-dan.com



Hi Dan,
You're coming through loud and clear!

--
Bonnie
NJ