|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 14th 03, 09:29 AM
|
|||
|
|||
CO2 Diffuser question
I have a pressurized CO2 system, the diffuser is a glass bell that is
usually 1/3 filled with water other 2/3 are the gas which is diffusing into the water thought a kind of a hard membrane - which worked very well. for some reasons the water are no longer in the bell which also means I cannot see the CO2 bubble count. could the CO2 pushed out the water I think it did.... does this indicates any problem ? 10x gizmo 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about copper | Marco Qualizza | Reefs | 5 | April 11th 04 08:43 PM |
| UGF Question | james mitchell | General | 12 | January 28th 04 06:54 PM |
| CO2 Diffuser question | EGMono | General | 0 | November 15th 03 09:50 PM |
| Air stone location and bubble size question | SA | General | 3 | November 2nd 03 11:29 PM |
| Lighting Question | MakitaSalesRep | Reefs | 4 | October 21st 03 07:35 PM |
Hybrid Mode
