|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 8th 03, 01:58 AM
|
|||
|
|||
Weird Question: Dimension of the Squid Water Director
I'm working on my piping, and have ordered a scwd, but want to finish my
piping, anyone know the width barb end to barb end and height bottom barb to the top of an output barb? Thanks 
|
|
#2
October 8th 03, 04:17 AM
|
|||
|
|||
|
Weird Question: Dimension of the Squid Water Director
Tip to Tip = 4 3/8"
Base to top edge of outlets = 4 9/16" Marc wrote: I'm working on my piping, and have ordered a scwd, but want to finish my piping, anyone know the width barb end to barb end and height bottom barb to the top of an output barb? Thanks -- Personal Page: http://www.sparklingfloorservice.com/oanda/index.html Business Page: http://www.sparklingfloorservice.com Marine Hobbyist: http://www.melevsreef.com
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
