![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hello,
I currently live in Phoenix, AZ and I was wondering if anyone had any advice about stores locally that have friendly service, knowledge, and good prices. Please let me know if anyone has had any good experiences here in the area. Or if you are looking to sell an old tank, I would be interested. Thank you, Matt |
#2
|
|||
|
|||
![]()
Buy quality components. Buy them one at a time if you must. It is
certainly cheaper in the long run. The Wal-Mart complete setups are a place to start but, the tank is not that great quality, the stands are terrible (but they don't fall ;-), and you will find the pumps, heaters, etc. to be the very minimum level of quality - just enough to keep from killing fish regularly. Find a couple of local fish stores near where you live. Buy a tank and stand there. Buy a really good quality tank and stand first because once you have it you never replace it. You will spend many hours a week looking at it so, make sure it is the best quality you can afford (within reason). I recently purchased a 50 gallon tank for $100. I really like the extra height and depth of these tanks. A 24 inch tall "show" tank has a lot of visual appeal for a main living area. The stands run ~$120 to $150 for an enclosed model (same tank size). Now, once you recover from that financial outlay, get a good filter and heater. The Emperor 400 from Marineland is solid starting point and runs $40 from http://www.bigalsonline.com, add a Rena heater ~$20 from the same place, some dechlorinator, and fish food you are at ~$80 with shipping. I like to add a small Tetra DeepWater air pump with a rectangular air stone (1inch by 6 inch) for those tiny bubbles and the visual appeal and you're done at about $100. Now, add the water and let the tank sit about week to cycle through any "bloom" that might occur. Now you're ready to add a few fish (not more then 4) to get the tank started right. I would suggest viewing all the fish at several pet stores at least once a week for a couple of weeks before you buy some. Find fish that are appealing to you and, try to avoid the "Noah's Ark" syndrome with one or two from each species. Right now I'm into large groups of schooling Tetra's myself and find their behavior to be much different in large groups versus isolation in an ocean of many. If you mix fish, make sure they are compatible (i.e. you are not buying expensive feeder fish for an aggressive predator in the tank - like Barbs and Neon Tetra's or similar bad combinations). wrote in message om... Hello, I currently live in Phoenix, AZ and I was wondering if anyone had any advice about stores locally that have friendly service, knowledge, and good prices. Please let me know if anyone has had any good experiences here in the area. Or if you are looking to sell an old tank, I would be interested. Thank you, Matt |
#3
|
|||
|
|||
![]()
Sidney, you do know MarineLand makes the Regent filters for WalMart right?
With a little playing and parts from MarineLand you can convert the Regent to an Emperor no problems.. My choise of HOT filters is a little different because of what I prefer and cost related issues ( I use the AC's from the 150 to the 300 because I can make my own filter media mixtures etc, and I also have foam media for any of these filters in one purchase ). I do agree with the mat tack particle board stands sold there are not a high qaulity item and the LFS probably have a better selection of better built units ( unless you want to make one yourself ). You can also check the local Penny Saver for good deals on tanks.... I bought two 55USG tanks for a mere $50 with a hand built stand that can support both of the tanks... A little cleaning and they looked new without any leaks. I purchased some of my filtration off of E bay, at a substainial savings ( these were new units or units with very little time on them ). take some time and research, research research, as this hobby will bring a lot of enjoyment for years to come...IMHO Tim.. "Sidney" wrote in message news:qKjDb.11896$pY.8132@fed1read04... Buy quality components. Buy them one at a time if you must. It is certainly cheaper in the long run. The Wal-Mart complete setups are a place to start but, the tank is not that great quality, the stands are terrible (but they don't fall ;-), and you will find the pumps, heaters, etc. to be the very minimum level of quality - just enough to keep from killing fish regularly. Find a couple of local fish stores near where you live. Buy a tank and stand there. Buy a really good quality tank and stand first because once you have it you never replace it. You will spend many hours a week looking at it so, make sure it is the best quality you can afford (within reason). I recently purchased a 50 gallon tank for $100. I really like the extra height and depth of these tanks. A 24 inch tall "show" tank has a lot of visual appeal for a main living area. The stands run ~$120 to $150 for an enclosed model (same tank size). Now, once you recover from that financial outlay, get a good filter and heater. The Emperor 400 from Marineland is solid starting point and runs $40 from http://www.bigalsonline.com, add a Rena heater ~$20 from the same place, some dechlorinator, and fish food you are at ~$80 with shipping. I like to add a small Tetra DeepWater air pump with a rectangular air stone (1inch by 6 inch) for those tiny bubbles and the visual appeal and you're done at about $100. Now, add the water and let the tank sit about week to cycle through any "bloom" that might occur. Now you're ready to add a few fish (not more then 4) to get the tank started right. I would suggest viewing all the fish at several pet stores at least once a week for a couple of weeks before you buy some. Find fish that are appealing to you and, try to avoid the "Noah's Ark" syndrome with one or two from each species. Right now I'm into large groups of schooling Tetra's myself and find their behavior to be much different in large groups versus isolation in an ocean of many. If you mix fish, make sure they are compatible (i.e. you are not buying expensive feeder fish for an aggressive predator in the tank - like Barbs and Neon Tetra's or similar bad combinations). wrote in message om... Hello, I currently live in Phoenix, AZ and I was wondering if anyone had any advice about stores locally that have friendly service, knowledge, and good prices. Please let me know if anyone has had any good experiences here in the area. Or if you are looking to sell an old tank, I would be interested. Thank you, Matt |
#4
|
|||
|
|||
![]()
I have the 55g Wal-Mart kit and am so far very satisfied with it. The
heater keeps the temperature stable I have never seen it fluctuate even a degree. The filter comes with an extension tube for the intake and seems to work fine plus the pads are very cheap to replace. The tank... I can see in and it doesn't leak what more do you want? I added and elite 802 pump with 2 air stone ornaments from petsmart to increase oxygenation and generate a better water flow. The stand holds the tank and doesn't fall or wooble and looks fairly attractive, that's really all I wanted. My only complaint is the hood only supports 2 -15 watt tubes no where near enough for plants and its impossible to adapt. Though all the kits are like that. "Sidney" wrote in message news:qKjDb.11896$pY.8132@fed1read04... Buy quality components. Buy them one at a time if you must. It is certainly cheaper in the long run. The Wal-Mart complete setups are a place to start but, the tank is not that great quality, the stands are terrible (but they don't fall ;-), and you will find the pumps, heaters, etc. to be the very minimum level of quality - just enough to keep from killing fish regularly. Find a couple of local fish stores near where you live. Buy a tank and stand there. Buy a really good quality tank and stand first because once you have it you never replace it. You will spend many hours a week looking at it so, make sure it is the best quality you can afford (within reason). I recently purchased a 50 gallon tank for $100. I really like the extra height and depth of these tanks. A 24 inch tall "show" tank has a lot of visual appeal for a main living area. The stands run ~$120 to $150 for an enclosed model (same tank size). Now, once you recover from that financial outlay, get a good filter and heater. The Emperor 400 from Marineland is solid starting point and runs $40 from http://www.bigalsonline.com, add a Rena heater ~$20 from the same place, some dechlorinator, and fish food you are at ~$80 with shipping. I like to add a small Tetra DeepWater air pump with a rectangular air stone (1inch by 6 inch) for those tiny bubbles and the visual appeal and you're done at about $100. Now, add the water and let the tank sit about week to cycle through any "bloom" that might occur. Now you're ready to add a few fish (not more then 4) to get the tank started right. I would suggest viewing all the fish at several pet stores at least once a week for a couple of weeks before you buy some. Find fish that are appealing to you and, try to avoid the "Noah's Ark" syndrome with one or two from each species. Right now I'm into large groups of schooling Tetra's myself and find their behavior to be much different in large groups versus isolation in an ocean of many. If you mix fish, make sure they are compatible (i.e. you are not buying expensive feeder fish for an aggressive predator in the tank - like Barbs and Neon Tetra's or similar bad combinations). wrote in message om... Hello, I currently live in Phoenix, AZ and I was wondering if anyone had any advice about stores locally that have friendly service, knowledge, and good prices. Please let me know if anyone has had any good experiences here in the area. Or if you are looking to sell an old tank, I would be interested. Thank you, Matt |
#5
|
|||
|
|||
![]()
My heater did in fact fluctuate. A Rena submersible can be placed along the
intake tube which cuts down visual clutter and puts the heater in a good water circulation path so it heats the entire 4 foot long tank. For a lightly loaded tank, the Regent filter works. Add more fish and live plants, it is marginal at best. It does not provide good water circulation unless placed carefully. I don't like DEAD water in my tank. The tank holds water and isn't opaque. Great, it meets the minimum requirement. It is narrow from front to back so, live plants touch both sides. The plastic surrounds are thicker then some other tanks so, more of your view is blocked by black plastic. Thin glass does not have the structural integrity of thicker glass but, my tank has not bowed enough to leak either. The stand is not as tall as other standard tank stands. Against a wall with nothing blocking the view, who cares? It is amazing what 4 inches does in tank stand height when it is placed in a dining room or living room where there are other objects that may be between you and the tank. The hoods are cheap plastic units with weak bulbs. You can upgrade them to a point. The first time you go from 30W of factory hood light to a pair of 65W PowerCompacts, you will be amazed at the difference in what you can see. There is no single right or wrong answer. This is just my experience. YMMV Sid "Steven S." wrote in message news:dyFFb.16764$VB2.37025@attbi_s51... I have the 55g Wal-Mart kit and am so far very satisfied with it. The heater keeps the temperature stable I have never seen it fluctuate even a degree. The filter comes with an extension tube for the intake and seems to work fine plus the pads are very cheap to replace. The tank... I can see in and it doesn't leak what more do you want? I added and elite 802 pump with 2 air stone ornaments from petsmart to increase oxygenation and generate a better water flow. The stand holds the tank and doesn't fall or wooble and looks fairly attractive, that's really all I wanted. My only complaint is the hood only supports 2 -15 watt tubes no where near enough for plants and its impossible to adapt. Though all the kits are like that. |
#6
|
|||
|
|||
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stores near the Monterey, California area | Clay Blankenship | General | 0 | September 20th 03 07:25 AM |