|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 10th 03, 04:31 PM
|
|||
|
|||
Durso question?
Have durso standpipe.
Am attempting to fine tune the length of the pipe as regards overflow height. http://www.rl180reef.com/pages/stand...-standpipe.htm . Using the "tee" (#5)on the durso as a reference, where exactly should the waterline in the overflow be? Halfway up the tee- keeping the horizontal part of the ell (#6) half full? Want to be sure *before* I cut... -- Toni http://www.cearbhaill.com/reef.htm 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lighting Question | MakitaSalesRep | Reefs | 4 | October 21st 03 07:35 PM |
| Another Lighting Question... | Mort | Reefs | 4 | September 9th 03 05:01 AM |
| Slightly OT but have a question | Teeb | Reefs | 9 | August 14th 03 10:33 PM |
| I need a very simple answer to a lighting and filter question. | Ben | General | 8 | July 26th 03 07:12 AM |
| Question about sand/ crushed coral | Brian McCarty | Reefs | 3 | July 14th 03 03:41 AM |
Threaded Mode