![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#3
|
|||
|
|||
![]()
On Sun, 1 May 2005 15:02:38 +0100, sophiefishstuff
wrote: my new (secondhand) tank came with a heater, which looks to be about the right wattage for a cold winter's night, but rather overdone for the summer... 35 (US) gallon; heater = 200W. Is this a problem? What I've usually seen on the spec sheet that comes inside the box with a new heater is that the manufacturer recommends 3-5 watts per gallon. This can also be found in various books and probably on the Net. In my personal experience 5 watts per gallon is too much, particularly in smaller tanks; and I'm talking about the heater functioning correctly, I'm not thinking of a situation where the heater gets stuck. Just for general use, these 5 watts are too powerful. I would never use anything stronger than a 100 watt heater in a 35 gallon tank. -Derek |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heater accuracy (Won Brothers)? | Bill Stock | General | 17 | March 11th 05 09:46 AM |
Heater accuracy (Won Brothers)? | Bill Stock | Tech | 17 | March 11th 05 09:46 AM |
When the Heater Breaks.... | Ami . | Goldfish | 10 | January 16th 04 06:57 PM |
Submersable Heater Melted. | Glenn Serpas | General | 2 | December 31st 03 06:19 PM |
Is it safe to hide the heater in a plastic tube on the inlet flow ? | Alan Silver | General | 7 | September 15th 03 05:04 PM |