|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
August 3rd 05, 05:42 PM
|
|||
|
|||
Pin the joints of the crossties (sleepers) with steel rod.......no way
is the water pressure going to overcome the sheer strength of a steel pin. Even a 20 or 30 penny spike used as a pin on a half lap joint or a through joint would be more than sufficient even for a higher outer frame..... ============================================== Put some color in your cheeks...garden naked! "The original frugal ponder" ~~~~ }((((o ~~~~~~ }{{{{o ~~~~~~~ }(((((o 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rec.ponds FAQ | Snooze | General | 0 | May 17th 05 03:05 AM |
| help needed please - just inherited a koi pond | brendan | General | 16 | July 25th 04 09:26 PM |
| New Small Pond.......Need Info Please | M.R. Wholesale Goods | General | 1 | July 14th 04 02:22 PM |
| New To Ponds, Would Appreciate Some Advice | WDiamond | General | 16 | March 31st 04 01:39 AM |
| new pond | Anonymous | General | 8 | September 9th 03 04:41 PM |
Threaded Mode