![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]() "Brian" wrote in message ... I'm just putting my experience out there, as a warning to others, to make sure your filter is running immediately after power outages. I wonder of others have experienced this problem. ======================== I've had a few Aquaclears to not start after an outage but no harm came to the impeller well, the motor or the impeller itself. After cleaning the slime off the impeller magnet, and the well itself - they'd start right up again. My Fluval always started after a power outage. -- Koi-Lo.... frugal ponding since 1995... My Pond & Aquarium Pages: http://bellsouthpwp.net/s/h/shastadaisy ~~~ }((((o ~~~ }{{{{o ~~~ }(((((o |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
fluval issue | Charles | General | 1 | November 22nd 05 07:27 PM |
fluval issue | Charles | Tech | 1 | November 22nd 05 07:27 PM |
fluval issue | Koi-lo | General | 7 | November 20th 05 11:09 PM |
fluval issue | Koi-lo | Tech | 7 | November 20th 05 11:09 PM |
FS: Fluval 104 Canister Filter (in DFW) | Sandy | Marketplace | 0 | July 29th 03 02:42 PM |