|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 14th 07, 12:00 AM
posted to rec.ponds
|
|||
|
|||
Pump is working
OK... it looks like an Earl Sheib abortion but it is working. We finally
found someone to work with the ID/OD problems. A 1 1/2" hose leaves the pump and hits a T. Off the tee, on each side, are reducers (ACE hardware) that take it to 1"... so there should be no backpressure on the pump. One 1" line goes to the filters and the other ends spewing water on the pond surface. -- RM.... Frugal ponding since 1995. rec.ponder since late 1996. My Pond & Aquarium Pages: http://tinyurl.com/9do58 Zone 6. Middle TN USA ~~~~ }((((* ~~~ }{{{{(ö 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Got the New Tank...working on plumbing | Glengoyne | General | 10 | October 9th 05 07:58 AM |
| newsgroup still working? | Steve | General | 7 | August 26th 05 01:38 PM |
| So... why am I working so hard? | coolchinchilla | General | 40 | July 23rd 05 08:55 AM |
| perfect working music! | caroline | General | 4 | September 20th 04 11:00 AM |
| Working with Acrylics - routing | Marc Levenson | Reefs | 12 | July 14th 03 01:17 PM |
Threaded Mode